Loading ...
Loading ...
Loading ...
En-5
● OPERATING INSTRUCTIONS ●
ABSENCE DETECTION
This function automatically changes the operation to energy-saving operation
when nobody is in the room.
I-SEE OPERATION
1
To activate this function, press until appears
on the operation display of the remote controller.
2
Press again to release ABSENCE DETECTION.
INDIRECT/DIRECT mode
The INDIRECT/DIRECT mode offers fi nely-tuned operation by locating where
an occupant is in the room.
1
Press during COOL, DRY, HEAT or AUTO
mode to activate the INDIRECT/DIRECT mode. This
mode is only available when the i-see control mode is
effective.
2
Each press of changes INDIRECT/DIRECT in
the following order:
(INDIRECT) : An occupant will be less exposed to
direct airfl ow.
(DIRECT) : Mainly the vicinity of an occupant will
be air-conditioned.
• Horizontal and vertical airflow directions will be automatically selected.
• When more than a couple of people are in a room, the INDIRECT/
DIRECT mode may work less effectively.
• If you still feel uncomfortable with the air direction determined by the
INDIRECT mode, adjust the air direction manually. Page 7
3
Canceling the i-see control mode automatically cancels
the INDIRECT/DIRECT mode.
• The INDIRECT/DIRECT mode is also cancelled when the VANE or
WIDE VANE buttons is pressed.
Note:
• Do not touch the i-see sensor. This may cause malfunction of the i-see sen-
sor.
• The intermittent operating sound is a normal sound produced when the i-see
sensor is moving from side to side.
Press during COOL, DRY, HEAT and AUTO mode
to activate the i-see control mode.
• Press gently using a thin instrument.
•
lights. (Operation display section)
• The default setting is “active”.
Press again to activate ABSENCE DETECTION.
• lights. (Operation display section)
Press again to release the i-see control mode.
Note:
Any person at the following places cannot be detected:
• Along the wall on which the air conditioner is installed
• Directly under the air conditioner
• Where any obstacle, such as furniture, is between the person and the air
conditioner
A person may not be detected in the following situations:
• Room temperature is high.
• A person wears heavy clothes and his/her skin is not exposed.
• A heating element of which temperature changes significantly is present.
• Some heat sources, such as a small child or pet, may not be sensed.
• A heat source and the air conditioner are more than 20 ft (6 m) apart.
• A heat source does not move for a long time.
1
2
3
i-see control mode
In the i-see control mode, the room temperature is controlled based on the
sensible temperature.
(INDIRECT) (DIRECT) (OFF)
JG79A977H01_en.indd 5 2014/11/10 13:08:23
Loading ...
Loading ...
Loading ...