Loading ...
Loading ...
Loading ...
20
INSTALLATION
15
Reinstall the side interlock button.
Reinstall the side interlock button removed in
step 7. Center the spring in the compartment
and insert the interlock button on top of it.
16
Reinstall the door cover.
Clean the glass on the door and door cover, if
necessary.
Make sure the three gray interlock buttons
are properly installed and that the top and
side lock rods are properly aligned where
they meet. Carefully lower the door cover into
place, aligning the holes in the cover with
the interlock buttons on the top and side and
the bumpers on the bottom. Take care not to
dislodge the lock rods while mounting the door
cover. Once the door cover is in place, secure
it with the 12 screws removed in step 4. The
ten similar screws go around the top and sides
of the door cover. Make sure to install the two
different screws on the bottom edge, in the
locations marked below.
Interlock
buttons
Side
interlock
button
Bumpers
17
Now, pick up the upper hinge pivot
removed earlier and rotate it 180 degrees.
Install the hinge on the top left side of the
cabinet.
18
Reinstall the door.
Press in the side interlock button on the left
side and hold it down while you press the
hinge pivot into the hinge assembly on the top
right side. If the door has been reassembled
correctly, the lock rod will slide back easily and
lock the pivot in place. The door is now ready
to remount on the opposite side of the dryer.
Two
large
screws
Two
small
screws
While supporting the door, install the two small
hinge screws removed in step 2. Test the
swing of the door to make sure the hinges and
latch are properly aligned and that the door
opens, closes and latches properly in both
directions.
If the door doesn’t operate smoothly, remove
the door and then the door cover to check
that the lock rods and interlock buttons are
properly mounted and aligned.
The interlock buttons should be oriented
correctly and operating smoothly. The interlock
rods should be in the proper position and
should not overlap at the contact point. (See
steps 15-17.)
If the door is damaged, or if the door does not
work after reassembly, contact the call center
at 1-800-243-0000.
MFL67731070_en_170711.indd 20 2017-07-11 오후 4:05:08
Loading ...
Loading ...
Loading ...