Loading ...
Loading ...
Loading ...
6
Align the front panel with the pedestal and snap in place.
NOTE: Follow the “Showroom Display Kit Installation
Instructions” if you wish to use the two retainer clips included
in the parts bag. Discard the retainer clips if not used.
12. Install pedestal front panel
36" (914 mm) tall models,
place wide edge of front
panel on bottom
38" (965 mm) tall
models, place wide edge
of front panel on top
11. Securely tighten jam nuts
When the washer/dryer is level, use a 9/16" open-end wrench
to securely tighten all four jam nuts against the pedestal.
IMPORTANT: The jam nuts must be tightened to avoid
vibration.
Locate the 1/4" hex-head screws on the top of each
pedestal foot. Reach inside the pedestal and use a
1/4" hex-head ratchet or open-end wrench to adjust the
feet up or down as needed to level the washer/dryer.
10. Adjust pedestal feet
Loading ...
Loading ...
Loading ...