Loading ...
Loading ...
Loading ...
4
INSTALLING THE PEDESTAL
Follow these instructions to install the pedestal on a washer
or dryer.
2. Washer transport bolts
Make sure that all four spacer pads are in place on the top
of the pedestal. Spacer pads reduce vibration between the
pedestal and the washer/dryer.
NOTE: If your washer/dryer has feet installed, remove them.
1. Locate spacer pads
Partially install two of the #12 x 5/8" hex-head sheet metal
screws in the lower holes. Leave a space of about 3/8" (10 mm)
between the screw head and the bottom of the washer/dryer.
2. Prepare the washer/dryer
Dryer Bottom
Washer Bottom
3. Attach the pedestal
4. Secure the pedestal
Move the pedestal against the washer/dryer bottom. Slide
the pedestal’s keyhole slots over the lower two partially
installed screws.
Position the pedestal toward the front of the washer/dryer and
install the two remaining hex-head sheet metal screws. Do not
tighten completely.
Locate the transport bolts on rear of washer. Transport bolts
must remain in washer while pedestal is installed. When laying
the washer on its back, hold the base down on the oor. Do
not remove the plastic lm, corner posts, or top cap.
Loading ...
Loading ...
Loading ...