Loading ...
Loading ...
Loading ...
22_ operating
Making Ice
• To fill the ice bucket to maximum capacity after
installation, follow these steps:
1. Allow your refrigerator to operate and cool
down for 24 hours (or 1 full day).
- Waiting 24 hours will allow your ice maker to
cool properly.
2. Dispense 4 to 6 ice cubes into the glass.
3. After 8, and then 16 hours, dispense a full
glass of ice.
• To test the ice maker, press the Test button
on the ice maker. You will hear the refrigerator
chime (ding-dong). When the chime sounds,
release the Test button.
• The chime sounds automatically again to let
you know the ice maker is working well.
If you want to remove the ice cubes
without using the ice bucket, please turn
the ice maker off and remove the ice
maker’s front cover from the ice maker.
Note that the ice cubes in the ice maker
can spill out over the drawer.
Do not put food in the ice bucket. If you
store food in the ice bucket, the food can
strike the ice maker when you open or
close the door, causing damage to the ice
maker.
Note that the ice cubes in the ice bucket
may spill out over the drawer when you
remove the ice bucket from the drawer.
If this occurs, be sure to clear the ice
cubes that spilled out of the drawer.
If a power failure occurs, ice cubes may
melt, and then freeze together when
the power comes back on, causing the
dispenser to stop working.
CAUTION
CAUTION
CAUTION
CAUTION
To prevent this problem, after a power failure, pull
out the ice bucket and discard the residual ice or
water.
If you use all the ice at once, you must
repeat ice making Steps 2 and 3, left.
However, only wait 8 hours before dispensing the
first 4 to 6 ice cubes. This will replenish the ice
cubes and ensure maximum ice production.
Using the ice off Function
When you select the Ice Off mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it difficult to
remove them.
To remove the ice bucket safely and avoid injury,
hold the bottom of the bucket with one hand and
the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight
out.
To put the ice bucket back in, push it firmly
straight back.
If the ice bucket is not pushed firmly into
place, ice in the bucket can melt.
If the bucket does not fit, turn the helix 90 degree
(see the last illustration on the right, below) and
try again.
• The inside of the ice bucket is very cold
when the refrigerator is operating.
Do not reach deep inside the ice
bucket.
• Use only the ice maker provided with
the refrigerator. The water supply to this
refrigerator must only be installed/connected
by a suitably qualified person.
Connect to a potable water supply only.
• To operate the ice maker properly, water
pressure of 20 ~ 125psi is required.
CAUTION
check
the water
level
Test button
DA68-02897A-15.indb 22 2018. 7. 9. �� 5:27
Loading ...
Loading ...
Loading ...