Loading ...
Loading ...
Loading ...
17
Performance Checklist
A qualified installer should carry out the following
checks:
Check top surface elements—glow red when turned
on. (VER models)
Check top surface elements (VIR models)
1. Starting with the left front element, turn the
corresponding knob ot hte HI position. Left front
indicator should flash.
2. Place an induction compatible piece of cookware
on the left front element. Left front indicator
should be solid.
3. Remove cookware and repeat steps fro other
elements.
Check hot surface indicator lights—glow red when
corresponding element is on.
Check oven bake function—bake element on full
power, center and outside broil elements at partial
power.
Convection bake function—bake and broil
elements the same with the convection fan on.
Check TruConvec™ function—TruConvec element
(behind convection fan cover) on and convection
fan on.
Check HI broil function–both broil elements at
full power.
Check LOW broil function—inner broil element
only.
Check convection broil function—both
broil elements at full power with convection fan
on.
Check self-clean function—door will lock
in approximately 30 seconds, the center and
outside broil elements will turn on and the bake
element will turn on at partial power. Check broil
elements through window to make sure they are
on, then abort self-clean cycle to unlock door.
NOTICE
When conducting performance test, do not run self-clean cycle
for more than 10 minutes with oven racks inside oven. This
could cause them to discolor due to the high temperature
required for self-cleaning.
Loading ...
Loading ...
Loading ...