Loading ...
Loading ...
Loading ...
HomeLink Universal Transmitter
rolling code garage door
opener. Test this by pressing
and holding the HomeLink
transmitter button you just
trained. If the red light blinks
for two seconds, then stays on,
you have a rolling code garage
door opener. You may be able
to verify this with the
manufacturer's documentation.
Go to "Training With a Rolling
Code System."
8. Repeat these steps to train the
other two transmitter buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate,
security system, etc.).
Training With a Rolling Code
System
For security purposes, newer
garage door opening systems use a
"rolling" or variable code.
Information from the remote
control and the garage door opener
are needed before the HomeLink
transmitter can operate the garage
door opener. The "Training the
Transmitter" procedure trains the
HomeLink transmitter to the proper
garage door opener code. The
following procedure synchronizes
the HomeLink transmitter to the
garage door opener so they send
and receive the correct codes.
It may be helpful to have someone
assist you with this procedure.
1. Make sure you have properly
completed the "Training the
Transmitter" procedure.
2. Find the "Training" button on
your garage door opener unit.
The location will vary,
depending on the manufacturer.
The manufacturer's
documentation may help.
3. Press the Training button on the
garage door opener unit until
the light next to the button
comes on, then release it. The
light may blink, or come on and
stay on. You then have
approximately 30 seconds to
complete the following steps.
CONTINUED
Instruments and Controls
TRAINING
BUTTON
Main Menu
Table of Contents
Loading ...
Loading ...
Loading ...