Loading ...
Loading ...
Loading ...
5
23. Microwave heating of beverages can result in delayed eruptive boiling,
therefore
care must be taken when handling the
container.
24. Young children should be supervised to ensure that they do not play with the appliance.
25. The appliances are not intended to be operated by means of an external timer
or
s
eparate
remote-control system.
26. Accessible parts may become hot during use. Young children should be kept away.
27. A steam cleaner is not to be used.
28. During use the appliance becomes hot. Care should be taken to avoid touching heating
elements inside the oven.
29. Only use the temperature probe recommended for this oven (for ovens provided with a
facility to use a temperature-sensing probe.)
30. WARNING: If the door or door seals are damaged, the oven must not be operated until it
has been repaired by a competent person.
31. WARNING: It is hazardous for anyone other than a competent person to carry out any
service or repair operation which involves the removal of a cover which gives protection
against exposure to microwave energy.
32. The rear surface of appliance shall be placed against a wall
.
33. WARNING: liquids and other foods must not be heated in sealed containers since
they are liable to explode.
34. WARNING: Only allow children to use the oven without supervision when adequate
instructions have been given so that the child is able to use the oven in a safe way and
understands the hazards of improper use.
35. The microwave oven is intended for heating food and beverages. Drying of food or
clothing and heating of warming pads, slippers, sponges, damp cloths and similar may
lead to the risk of injury, ignition or fire.
36. For microwave ovens having an additional decorative door, the microwave must be
operated with the decorative door open.
37. This microwave oven shall only be used when built into a cabinet.
38. The socket must be installed or replaced by a qualified electrician. If the plug is no longer
accessible following installation, an all-pole disconnection device must be present on the
installation side with a contact gap of at least 3mm.
Loading ...
Loading ...
Loading ...