Loading ...
Loading ...
Loading ...
8
Add Rinse Aid
■ Your dishwasher is designed to use rinse aid for good drying
performance. Without rinse aid your dishes and dishwasher
interior will have excessive moisture. The heat dry option will
not perform as well without rinse aid.
■ Rinse aid keeps water from forming droplets that can
dry as spots or streaks. They also improve drying by
allowing water to drain off of the dishes after the final
rinse.
■ Rinse aid helps to reduce excess moisture on the
dish racks and interior of your dishwasher.
■ Check the rinse aid indicator. Add rinse aid when indicator
drops to “Refill” level.
■ To add rinse aid, turn the
dispenser cap ¼ turn
counterclockwise and lift
off. Pour rinse aid into the
opening until the indicator
level is at “Full.” Replace
the dispenser cap and turn
to “Lock.” Make sure cap is
fully locked.
NOTE: For most water conditions, the factory
setting will give good results. If you have hard
water or notice rings or spots, try a higher
setting. Turn the arrow adjuster inside the
dispenser to change rinse aid settings.
■ If you are experiencing poor dry
performance, you may want to try a higher
setting in your rinse aid dispenser.
Select a Cycle (cycles vary by model)
Press and hold the desired cycle button until the corresponding
light is on. See “Cycle and Option Descriptions” charts in the
following section.
NOTE: Heavier cycles and options affect cycle length. Some
cycles and options will take up to 3¹⁄₂ hours to complete.
Select Options (options vary by model)
You can customize your cycles by pressing the options desired.
Start or Resume a Cycle
■ Run hot water at the sink nearest your dishwasher until the
water is hot. Turn off water.
■ If the Start/Resume button is located on top of door,
push door firmly closed within
3 seconds of pressing START/RESUME. If door is
not closed within 3 seconds, the start button LED
will flash, an audible tone will be heard, and cycle will not start.
IMPORTANT: If anyone opens the door (such as, for adding a dish,
even during the Delay Hours option), the START/RESUME button
must be pressed each time.
■ If your Start/Resume button is located on front of door, push
door firmly closed. The door latches automatically. Select the
wash cycle, options and press START/RESUME or press
START/RESUME to repeat the same cycle and options as in
previous wash cycle.
■ You can add an item anytime while the Add Dish light is on.
Open the door slowly and add the item. Close the door firmly.
Press START/RESUME.
■ The Clean indicator glows when the cycle is finished. Sanitized
glows when Sani Rinse option is selected and sanitization
levels occur.
STEP 3
Full
Add
STEP 4
Loading ...
Loading ...
Loading ...