To help keep your product running its best, purchase genuine parts and accessories directly from BISSELL.
www.bissell.com
Need help?
Call:
1-800-237-7691
Mon-Fri: 8am to 10pm ET
Sat: 9am to 8pm ET
Visit:
www.bissell.com/contact-us
How to Replace Your Vacuum’s Drive Belt
BISSELL Part # 32074
1. Unplug the vacuum from electrical outlet.
2. Place handle in the Low position and turn vacuum cleaner over so
bottom side is up.
3. For standard models, remove the four screws as shown with a
Phillips Head Screwdriver. Lift the Brush Cover off.
4. For wide cleaning path models, lift tab 1 and release the three
latches in order 2-4 as marked. Lift the Brush Cover off.
5. Grasp Rotating Floor Brush at both ends and lift.
6. With Rotating Floor Brush removed, grasp old Drive Belt and
remove from Motor Pulley. Discard old Drive Belt.
7. Place new Drive Belt over Motor Pulley and stretch other end other
Rotating Floor Brush in the space between the bristles.
8. Place ends of Rotating Floor Brush down into slots on sides.
9. Turn Rotating Floor Brush by hand several times in the direction
of Motor Pulley. If properly installed, Drive Belt will center itself on
Rotating Brush.
10. Reposition Brush Cover and screw or snap back into place. Check
to be sure all screws and latches are secure.
