Loading ...
Loading ...
Loading ...
LED Lighted Crevice Tool
Vacuum Motor Protection
Pull tabs out of battery door area
before use to activate. Connect
to wand or hose and the LED
Light will automatically come on.
To replace LED battery, unscrew the small screw
with a Phillips head screw driver. Pull cover off to
reveal two batteries (CR1632 3V). Slide and pull
out each battery and replace with new. Be sure the
“+” sign on battery is facing out. Dispose of used
battery promptly. Keep away from children. Do not
disassemble and do not dispose of in fire.
Turn vacuum OFF and unplug from electrical outlet.
Possible areas that could clog.
NOTE:
When the small tab on the connection point of Crevice tool comes into
contact with the handle, wand, or hose; that triggers the LED light to come on.
NOTE: The thermal protector controls the main vacuum motor only, not the
brush motor. If the thermal protector activates, brush and lights will continue to
operate normally; however, there will be no suction.
www.BISSELL.com
10
Filter
Filter
Upper
Hose
Lower
Hose
Brush Roll
An internal thermal protector has been designed into your vacuum to
protect it from overheating. When the thermal protector activates, the
main vacuum motor will stop operating. The front lights will remain on,
even though the motor turns off. If this happens, proceed as follows.
When the motor cools for approximately
30 minutes, the thermal protector automatically
resets and cleaning may continue. If the vacuum
will not turn on or the thermal protector continues
to activate, your vacuum may need servicing.
Contact BISSELL Consumer Care.
Check for the source of overheating problem (full
dirt cup, dirty filters or, a clog) and fix by following
the maintenance instructions.
1
2
1
2
3
Loading ...
Loading ...
Loading ...