Loading ...
Loading ...
Loading ...
Page 13
DANGER: The product must be
connected to the mains supply
only by an authorised and
qualified person. The product's
warranty period starts only after
correct installation. The
manufacturer shall not be held
responsible for damages arising
from procedures carried out by
unauthorised persons.
DANGER: The power cable must
not be clamped, bent or trapped
or come into contact with hot
parts of the product. A damaged
power cable must be replaced by
a qualified electrician. Otherwise,
there is risk of electric shock,
short circuit or fire!
Connection must comply with national
regulations.
The mains supply data must correspond to
the data specified on the type label of the
appliance. Type label is at the rear
housing of the appliance.
Power cable of your product must comply
with the values in "Technical
specifications" table.
DANGER: Before starting any
work on the electrical installation,
disconnect the appliance from the
mains supply. Risk of electric
shock!
The power cable plug must be
within easy reach after installation
(do not route it above the hob).
Gas connection
DANGER: Product can be
connected to gas supply system
only by an authorised and
qualified person. Risk of
explosion or intoxication due to
unprofessional repairs! The
manufacturer shall not be held
responsible for damages arising
from procedures carried out by
unauthorised persons.
DANGER: Before starting any
work on the gas installation,
disconnect the gas supply.
There is the risk of explosion!
Gas adjustment conditions and values are
stated on labels (or on type label).
Electrical connection
Connect the product to a grounded outlet/
line protected by a fuse of suitable capacity
as stated in the "Technical specifications"
table. Have the grounding installation made
by a qualified electrician while using the
product with or without a transformer. Our
company shall not be liable for any damages
that will arise due to using the product
without a grounding installation in
accordance with the local regulations.
Plug the power cable into the socket.
Make sure that the skirting sections
on the lower housing of the hob are
filled with putty.
Installing the product
1. Remove burners, burner caps and grills
on the hob from the appliance.
2. Turning the hob upside down, place it on
a flat surface.
3. In order to avoid foreign substances and
liquids penetrating between the hob and
the counter, please apply the putty
supplied in the package on the contours
of the lower housing of the hob, making
sure that the putty does not overlap.
4. Apply the putty by bending it around the
corners as in the figure.
Installation and connection
The product must be installed in accordance
with all local gas and electrical regulations.
5. Turning the hob again, align and place it
on the counter.
Loading ...
Loading ...
Loading ...