Loading ...
Loading ...
Loading ...
5
Changing the Water Filter
Style 1
1. Locate the water filter cover door in the base grille, and pull open
the filter door. The filter will be released and then be ejected as the
door is opened.
2. When the door is
completely open,
pull the filter
straight out.
NOTE: There may
be some water in
the filter. Some
spilling may occur.
Use a towel to wipe
up any spills.
3. Take the new filter out of its packaging and remove the covers from
the O-rings. Be sure the O-rings are still in place after the covers
are removed.
4. With the arrow pointing to the left (toward the filter cover doors
hinge), align the new filter with the filter housing and slide it into
place. The filter cover door will automatically begin to close as the
new filter is inserted.
5. Close the filter cover door completely in order to snap the filter into
place. You may need to press hard.
6. Flush the water system. See “Water and Ice Dispensers.”
A. Water filter cover door
The light will turn on red. T
his tells you that it is almost time to
change the filter.
It is recommended that you replace the filter when the status light
changes to red OR water flow to your water dispenser or ice
maker decreases noticeably.
NOTE: The filter should be replaced at least every 6 months
depending on your water quality and usage.
Resetting the Filter Status
The reset button is located on the control panel in the
refrigerator compartment. To reset the status light after changing
the filter, press the button TEMP SETTING within 3 seconds.
The status light will change from red to off when the system is
reset.
A
Style 2
1. Locate the water lter cover door in the base grille, and pull
open the lter door.
A
A. Water lter cover door
2. Twist the water lter and turn 90° counterclockwise to unlock.
3. Pull the lter out of the housing.
4. Remove the water lter cap from the water lter.
5. Install the water lter cap onto the new lter. Be sure to align
the arrows so the grooves in the lter align with the ribs in the
lter cap.
6. Insert the lter into the housing.
Loading ...
Loading ...
Loading ...