Loading ...
Loading ...
Loading ...
24
Installation requirements
❏ This appliance must be connected to a 220/240
V 50 Hz mains electricity supply using an
earthed plug.
❏ It must be protected with a 10 A slow-action fuse.
❏ Should an extension lead be needed, this lead
must be at least 1.5 mm
2
per terminal thick, no
more than 25 m. long and earthed.
❏ There is a cavity at the back of the appliance for
the mains electricity lead.
❏ Do not allow water to enter the appliance.
❏ Do not block the air inlets or outlets on your
appliance, especially when used for heating.
❏ To ensure correct appliance operation, maintain
minimum distances of 20 cm to adjacent objects.
see fig 4.
❏ The mains electricity supply connection cable
must only be replaced by authorised
members of the manufacturer’s Official
Technical Service.
❏ When the appliance is switched on and set to
work in dehumidification mode, the user may
hear a whistling or bubbling sound. There is
no cause for concern; these noises are not
symptomatic of a fault.
❏ Be careful on removing the tank from the
appliance when full of water. Hold the sides
gently but firmly and try to keep the tank in
as upright a position as possible at all times.
❏ If the appliance is turned off and then turned
back on again, there is a 3-minute interval
before the compressor starts up again. This
interval is necessary in order for the
appliance to work properly.
Operation
warnings
The appliance is fitted with wheels in order to make
it easier to move. Should it be necessary to tilt the
appliance in order to move it, empty the removable
water tank beforehand. See Cleaning and
Maintenance, "Emptying condensed water".
❏ You should not turn the appliance back on again
for a minimum period of one hour.
Transportation
requirements
Fig. 4
mín.
20 cm.
mín.
20 cm.
Loading ...
Loading ...
Loading ...