Loading ...
Loading ...
Loading ...
111
MAINTENANCE
Battery
Improperly connecting or disconnecting battery cables can result in an explosion
and cause serious injury or death. When removing the battery, always
disconnect the negative (black) cable first. When reinstalling the battery, always
connect the negative (black) cable last.
Battery Removal
1. Place the transmission in PARK. Disconnect the battery hold-down
strap. Remove the battery cover (if equipped).
2. On conventional batteries, remove the battery vent tube.
3. Disconnect the black (negative) battery cable first. Disconnect the
red (positive) battery cable last.
4. Lift the battery out of the vehicle. Be careful not to tip a conven-
tional battery sideways, which could spill electrolyte. If electrolyte
spills, immediately wash it off with a solution of one tablespoon
baking soda and one cup water to prevent damage to the vehicle.
Battery Installation
1. Ensure that the battery is fully charged. Place the battery in the bat-
tery holder.
2. With conventional batteries, install the battery vent tube. The vent
tube must be free of obstructions and securely installed. Route the
tube away from the frame and vehicle body to prevent contact with
electrolyte.
Battery gases could accumulate in an improperly installed vent tube and cause
an explosion, resulting in serious injury or death. Always ensure that the vent
tube is free of obstructions and is securely installed as recommended.
3. On conventional batteries, coat the terminals with dielectric grease
or petroleum jelly.
4. Connect and tighten the red (positive) cable first. Connect and
tighten the black (negative) cable last.
5. Install the battery cover (if equipped). Secure the battery hold-down
strap.
6. Verify that cables are properly routed. Cables should be safely
tucked away at the front and rear of the battery.
Loading ...
Loading ...
Loading ...