Loading ...
Loading ...
Loading ...
Operations
English52
Operations
Auto Fill Water
Pitcher
If the Lock indicator ( ) is off, press and hold Fridge for 3 seconds
to turn Auto Fill Water Pitcher on. Then, open the left door of the
fridge and insert the water tank. Close the door and the water
tank starts to ll with water up to the preset level.
If the Lock Indicator ( ) is on, indicating Control Lock is active,
press and hold Door Alarm for 3 seconds to deactivate Control
Lock. When the Lock indicator goes out, immediately press and
hold Fridge for 3 seconds to turn Auto Fill Water Pitcher on. Then,
open the left door of the fridge and insert the water tank. Close
the door and the water tank starts to ll with water up to the
preset level.
NOTE
When you turn off Control Lock, you must press and hold Fridge
within one minute or the Control Lock function will automatically
reactivate. You cannot turn the Auto Fill Water Pitcher function
on if Control Lock is active. For more information on Control Lock,
see page 57.
To turn the function off, press and hold Fridge again for
3 seconds.
NOTE
• By default, Auto Fill Water Pitcher is disabled. Enable this
function after you have installed the water line.
• If you open the door or push the dispenser lever, this function
is stopped temporarily.
• The Auto Fill Water Pitcher indicators blink if there is a leak.
This may occur because the water tank overows, or the
water-line or water-level sensor fails. If this is the case, follow
these steps.
a. Open the rubber cap and drain water.
b. When draining is complete, the indicators stop blinking and
turn solid.
c. Close the rubber cap.
• If the indicators continue to blink, this might be a system
failure. Contact a local service center.
Untitled-2 52 2019-07-08 11:46:25
Loading ...
Loading ...
Loading ...