MDB7959SHK User Manual

Loading ...

Copper tubing only: Put the tubing into the 90° elbow tting

as far as it will go. (The copper tubing bends and kinks easily.)

Slide the nut and ferrule forward and start the nut onto the

elbowthreads.

NOTE: To avoid vibration during operation, route the water

supply line so that it does not touch the dishwasher base,

frame,or motor. Go to Step 17.

Flexible braided line: Conrm the exible braided line is long

enough. See the “Tools and Parts” section at the front of the

guide for part details and orders.

Get

" compression x

" hose tting with 90° elbow. See

the “Tools and Parts” section at the front of the guide for part

details and orders. Connect the

" compression tting of the

90° elbow tting to the water supply line. Attach such that the

" connection is facing upward as shown above.

15. Slide nut and ferrule onto tubing

(copper tubing only)

Nut

Ferrule

16. Flexible line

17. Add 90° elbow tting to the

watersupply line

CONNECT FILL HOSE TO FILL VALVE

Be sure rubber washer is properly seated in tting. Slide the

" tting of the 90° elbow up to the valve and hand tighten to

avoid cross-threading. Hand tighten until the coupling is tight.

Using pliers, check the tightness of the coupling. An additional

turn may be required to seal the rubber gasket. Route

ll hose out the rear left side of unit.

NOTES:

■ Do not use Teon

®†

tape with compression ttings.

■ Do not over-tighten. Damage to the coupling can result.

DRAIN HOSE CONNECTION

Place towel under drain hose to catch any water in drain hose.

Place the small (green) drain hose clamp onto the small end

ofthe drain hose. Push the new drain hose into the rubber

drainhose connector up to the drain hose stop.

Using pliers, squeeze open the small drain hose clamp and

slide it onto the connector between stops.

†

TEFLON is a registered trademark of Chemours.

18. Tighten 90° elbow tting to valve

19. Connect drain hose

Stop

Drain hose stop

Drain hose

Rubber drain hose

connector

Small clamp

20. Slide clamp onto connector