Loading ...
Loading ...
Loading ...
12
Measure height of cabinet opening from underside of
countertop to oor where dishwasher will be installed.
Be sure to measure the lowest point on the underside
of the countertop and the highest point on the oor.
Adjust both front leveling legs to the same height. Put the rear
wheels in the correct position according to the “Dishwasher
Height Adjustment Chart.”
NOTE: If the minimum cabinet opening height is less
than 34" (864 mm), the rear wheels can be removed for
additionalclearance.
This will allow the dishwasher to t into a 33
1
/
2
" (851 mm)
highcabinet opening, but the dishwasher will be more
difculttomove. Measurements are approximate.
11. Measure cabinet opening
Dishwasher Height Adjustment Chart
Cabinet opening
height
Front legs
height
Wheel
position
Insulation
blanket
33
1
/
2
" (851 mm)
3
/
8
" (9.8 mm) Removed Cut
34" (864 mm)
9
/
16
" (14 mm) 1 No Cut
34
1
/
4
" (871 mm)
13
/
16
" (21 mm) 2 No Cut
34
1
/
2
" (876 mm)
11
/
16
" (27 mm) 3 No Cut
Front legs – A
Refer to the “Dishwasher Height Adjustment Chart” for wheel
position and for height of front legs needed for your cabinet
opening height.
Remove and discard the plastic rail cover on each side of
thedishwasher frame. To remove the plastic rail cover, push
upward and back to unsnap it from the dishwasher frame.
CONNECT WATER LINE TO FILL VALVE
– For Copper line, begin with Step 14
– For Flexible line, begin with Step 16
If using copper tubing, measure overall length of copper
tubing required to reach the water supply, cut to length, and
attach with compression ttings.
12. Adjust wheels and legs
13. Remove plastic rail cover
(only on certain models)
Plastic
rail cover
14. Copper water line
Loading ...
Loading ...
Loading ...