Loading ...
Loading ...
Loading ...
13
EN
Installation Place
Requirements
Location
2 cm2 cm
10 cm
Level oor : Allowable slope under the entire
appliance is 1°.
Power outlet : Must be within 1.5 meters of
either side of the location of the appliance.
Do not overload the outlet with more than one
appliance.
Additional Clearance : For the wall, 10 cm:
rear/2 cm: right & left side
Do not place or store laundry products on top
of the appliance at any time.
These products may damage the nish or
controls.
WARNING
The plug must be plugged into an appropriate
outlet that is properly installed and grounded
in accordance with all local codes and
ordinances.
Positioning
Install the appliance on a at hard oor.
Make sure that air circulation around the
appliance is not impeded by carpets, rugs, etc.
Never try to correct any unevenness in the
oor with pieces of wood, cardboard or similar
materials under the appliance.
If it is impossible to avoid positioning the
appliance next to a gas cooker or coal burning
stove, an insulation (85x60 cm) covered with
aluminum foil on the side facing the cooker
or stove must be inserted between the two
appliances.
Do not install the appliance in rooms where
freezing temperatures may occur. Frozen
hoses may burst under pressure. The
reliability of the electronic control unit may be
impaired at temperatures below freezing point.
Ensure that when the appliance is installed,
it is easily accessible for an engineer in the
event of a breakdown.
With the appliance installed, adjust all four
feet using a transit bolt spanner to ensure
the appliance is stable, and a clearance of
approximately 20 mm is left between the top
of the appliance and the underside of any
work-top.
If the appliance is delivered in winter and
temperatures are below freezing, place the
appliance at room temperature for a few hours
before putting it into operation.
WARNING
This equipment is not designed for maritime
use or for use in mobile installations such as
caravans, aircraft etc.
Electrical Connection
Do not use an extension cord or double
adapter.
Always unplug the appliance and turn off the
water supply after use.
Connect the appliance to an earthed socket in
accordance with current wiring regulations.
The appliance must be positioned so that the
plug is easily accessible.
Repairs to the appliance must only be carried
out by qualied personnel. Repairs carried out
by inexperienced persons may cause injury
or serious malfunctioning. Contact your local
service centre.
Loading ...
Loading ...
Loading ...