Loading ...
Loading ...
Loading ...
7
ERROR MESSAGES
If ERR message is shown on display, with relevant acoustic sig-
nal, the oven had a malfunction. Press START/STOP button (M)
for 5 seconds to reset the control and disconnect the plug from
wall outlet. Check troubleshooting section.
SETTING THE CLOCK
The rst time the appliance is connected to the main electricity
supply or after it has been without power for some time, it will
beep and “01 :00 am” blink on the display.
After 5 seconds the display will turn o, since the clock has not
been set, and the electronic control will go into stand-by mode.
To set the time, proceed as follows:
Press the Clock button (G) for at least 2 seconds.
The hour ashes.
Set the hour with
Time/temperature/toast color/pizza size/slices/
tray dial
(N).
Press the
SET button
(O). The minutes ash.
Set the minutes with Time/temperature/toast color/pizza size/
slices/ tray dial (N).
Press the
SET button
(O). The set time is displayed.
If you want to adjust the time later, repeat the setting procedure
described above. The electronic control must be in stand-by
mode to adjust the clock.
OVEN FUNCTION
In the stand-by mode, the Display shows the
clock (if set)
or 01:00.
• Press any button/key (G H I M O) or turn any dial (L N). The oven
turns on. The modiable values ash.
If there are no buttons pressed or dials turned within 2 minutes of
the selection mode function, the control defaults back into stand-
by mode.
• Turn the Function selection dial (L) to select the desired function.
• Turn the
Time/temperature/toast color/pizza size/slices/ tray
dial
(N)
to set the time if needed (not required in some pro-
grams).
• Press the SET button (O) to set the temperature.
• In some functions the temperature is automatically set (the dis-
play doesn’t show the preset temperature).
• Press the START/STOP button (M) to start cooking. The red ON
light (T), that is located around the edge of the START/STOP
button (M), turns on. When the timer elapsed, the display shows
“End” and plays a sound signal.
Press START/STOP button (M) to reset the oven. The oven goes
into stand-by mode. In the BAKE, CONVECTION, ROAST, REHEAT
and COOKIES functions, the oven plays a sound signal when the
rst target temperature is reached. In BAKE, ROAST, REHEAT and
CONVECTION function it is possible to check the internal tempera-
ture by pressing the Internal temperature check button (I). The
temperature is displayed for 5 seconds.
• It is possible to choose the temperature visualization in °F or in °C.
Default setting is in °F. To change this setting, select BAKE, ROAST,
REHEAT or CONVECTION function, press Internal temperature
check button (I) 1 time. The visualization will change to °C with
acoustic signal. To come back to °F visualization repeat the same
oparation.
Loading ...
Loading ...
Loading ...