Loading ...
Loading ...
Loading ...
25
ERROR
MESSAGE ON
DISPLAY
DESCRIPTION
POSSIBLE
PROBLEMS
SOLUTION
E0:28
Err
Electronic control cool-
ing system problem
The electronic control
detected a malfunc-
tion on its automatic
cooling system
Record the error number.
Disconnect the plug from wall outlet.
Check that vent openings located on bottom side or top
side of the oven are not obstructed by foreign objects
such as fabrics , papers or similar.
Remove any material from supporting surface where the
oven is located or from top side of the oven cover.
If above case was not , and same error occur again , the
electronic control could be damaged. Contact a De’Long-
hi customer service reporting the error number.
E0:29
Err
Electronic control cool-
ing system problem
The electronic control
detected a malfunc-
tion on its automatic
cooling system
Record the error number.
Disconnect the plug from wall outlet.
Check that vent openings located on bottom side or top
side of the oven are not obstructed by foreign objects
such as fabrics , papers or similar.
Remove any material from supporting surface where the
oven is located or from top side of the oven cover.
If above case was not , and same error occur again , the
electronic control could be damaged. Contact a De’Lon-
ghi customer service reporting the error number.
POSSIBLE PROBLEMS SOLUTION
Oven will not switch ON
• Check that the power plug is properly inserted into wall outlet
• Insert the power plug into a dierent outlet
• Verify the circuit breaker
If above solution do not solve the problem , probably the oven had a malfunction. Contact a
De’Longhi customer service.
LCD display light has gone
out
The oven goes in standby mode , when not used for 120 seconds , if Clock was not set.
When Clock is set , the display light is kept ON
Clock setting has gone out
If the LCD display light has gone out even if Clock was previously set , a power supply interruption
greater than 5 seconds occurred. The electronic control has been reset. Set the Clock again.
Oven lamp is OFF while oven
is ON
• The bulb is broken. Replace the bulb.
• The bulb is not properly screwed into its housing. Verify that it is completely screwed.
If above solution do not solve the problem , probably the electronic control of the lamp had a
malfunction. Contact a De’Longhi customer service.
The pizza does not cook
evenly
Some large pizza , or particular dough pizza may brow unevenly .We suggest in these cases to
turn half way through the cooking time the pizza for a perfect nal result.
Steam coming out from
housing
This is normal. The oven is vented to release excessive steam created from bread or high-moisture
content foods.
Water dripping on internal
glass
This is normal. The condensation created by toasting bred and frozen bred will run down the
inside of door glass , and collected into a special slot on internal lower side of door.
Loading ...
Loading ...
Loading ...