Loading ...
Loading ...
Loading ...
15
Replacement Parts
If replacement parts are needed for your dryer,
contact the source where you purchased your dryer.
CAUTION: Label all wires prior to
disconnection when servicing controls. Wiring
errors can cause improper and dangerous
operation. Verify proper operation after
servicing.
WARNING: Destroy the carton and
plastic bags after the parts are unpacked.
Children might use them for play. Cartons
covered with rugs, bedspreads or plastic sheets
can become airtight chambers causing
suffocation. Place all materials in a garbage
container or make materials inaccessible
to children.
WARNING: The instructions in the
manual and all other literature included with
this dryer are not meant to cover every possible
condition and situation that may occur. Good
safe practice and caution MUST be applied
when installing, operating and maintaining
any appliance.
Gas Connection for Gas Dryers
Remove the shipping cap from gas pipe at the
rear of the dryer.
NOTE: DO NOT connect the dryer to LP gas service
without converting the gas valve. An LP conversion
kit (Pub. No. 14-A038) MUST be installed by a
qualified gas technician.
Connect a 1/2″ (1.27 cm) I.D. semi-rigid
or approved pipe from gas supply line to
the 3/8″ (0.96 cm) pipe located on the back
of the dryer. Use a 1/2″ to 3/8″ (1.27 cm to
0.96 cm) reducer for a connection. Apply an
approved thread sealer that is resistant to the
corrosive action of liquefied gases on all pipe
connections.
Open the shutoff valve in the gas supply line.
Test all connections by brushing on a soapy
water solution.
WARNING:NEVER TEST FOR GAS
LEAKS WITH AN OPEN FLAME.
NOTE: On gas dryers, before the burner will light,
it is necessary for the gas line to be bled of air.
If the burner does not light within 45 seconds the
first time the dryer is turned on, the safety switch
will shut the burner off. If this happens, turn the
dryer off and wait 5 minutes before making another
attempt to light.
4
3
2
1
Before Operating the Dryer
Connect the exhaust duct to outside exhaust
system. Use duct tape to seal all joints.
With the dryer in its final position, adjust one or
more of the legs until the dryer is resting solidly
on all four legs. Place a level on top of the dryer.
THE DRYER MUST BE LEVEL AND RESTING
SOLIDLY ON ALL FOUR LEGS.
Plug the power cord into a grounded outlet.
NOTE: Check to ensure the power is off at circuit
breaker/fuse box before plugging the power
cord into the outlet.
Turn on the power at the circuit breaker/fuse
box.
CAUTION: Before operating the
dryer, make sure the dryer area is clear and
free from combustible materials, gasoline,
and other flammable vapors. Also see that
nothing (such as boxes, clothing, etc.)
obstructs the flow of combustion and
ventilation air.
Run the dryer through a cycle check for proper
operation.
Place these instructions in a location near the
dryer for future reference.
6
5
4
3
2
1
Customer Service
Care and CleaningSafety Instructions
Installation Instructions
Loading ...
Loading ...
Loading ...