Loading ...
Loading ...
Loading ...
10
Chapter 7: USING THE DEVICE
1. Connect the 2 wires to the TENS control unit.
2. Place Belt around your torso. Position it on the area of the body to be treated.
3. Turn the Device ON by pressing the “ON/OFF” button.
4. To change to another program press the “PRG” button.
5. To change the timer, press the “TIMER” button.
6. The device will turn off automatically if the timer was set (count down minutes are shown on the
display). If it was set to C (continuous) the device has to be turned OFF manually.
7. To turn the device OFF manually, press the “ON/OFF” button for 3 seconds.
Note 1:
When the device is in use and the “PRG” button is pushed, the intensity levels will change to “0” and
the last selected program starts ashing.
Note 2:
If no button is pushed for 10 seconds while in programming mode, the device will stop ashing. To
return into programming mode follow steps above by pressing the “PRG” button.
Note 3:
If the device is in programming mode (intensity bars are at “0”), the device will automatically turn
OFF after 60 seconds if no button is pushed.
Note: Use care when you plug and unplug the wires. Pulling on the lead wire instead of its insulated
connector may cause wire breakage.
Caution: Never insert the plug of the lead wire into an AC power supply or other equipment not
specied as safe for the lead wires.
Chapter 8: ENDING YOUR TREATMENT SESSION
After the device shuts off, use the following steps as a quick reference for ending your session:
• Disconnect the lead wire(s) from the control unit.
• Remove the wires from the TENS unit.
• You can leave the pads on the belt, but the exposed side has to be covered with the plastic
backing. Use the 4 plastic backings labeled “no” and stick them onto the pads, this will increase
the lifespan of these pads.
• When removing electrodes, always pull in the direction of hair growth. DO NOT REMOVE
ELECTRODES WHILE THEY ARE CONNECTED TO THE UNIT TO AVOID ANY ELECTRIC
DISCHARGE. Do NOT pull on the wires, but peel off on the corner of the electrode.
• Disconnect the lead wire(s) from the Belt.
• Store the components in the storage bag.
Loading ...
Loading ...
Loading ...