14565 Use & Care Guide

Loading ...

Deluxe Adjustable 2-Position Rack

You can raise or lower the top rack approximately 2" (5 cm)

to t tall items in either the top or bottom rack. Adjusters are

located on each side of the top rack. Each adjuster has 2

preset positions.

1. To raise, lift rack until both sides are at the same height

and lock.

2. To lower, depress both tabs on rack adjusters, as shown,

and lower.

Removable Top Rack

The removable rack allows you to wash larger items such as stockpots, roasters, and cookie sheets

inthe lower level rack.

IMPORTANT: Remove dishes prior to removing the upper rack from the dishwasher.

To remove the rack:

1. To gain access to the track stops, pull the upper rack forward about halfway out of the tub.

2. Press on the edge of the ridged area on the track stop while tipping the track stop toward the

center of the dishwasher. This action releases a small retaining tab that locks the track stop to

thetrack (see Track stop - left).

NOTE: It is helpful to use 2 hands. Take special note of the orientation of the track stops

3. With the retaining tab released, pull the track stop straight toward the opposite track to remove it.

4. After removing both track stops, gently pull the top rack out of the tracks by rolling it toward you.

5. Replace the track stops by coming up from under the track and slipping the lower tab of the track

stop into the lower slot of the track (see Track stop - right) and rotate the track stop into place. Then

press on the edge of the ridged area while pushing the track stop straight toward the track. This

action locks the retaining tab back into place.

6. Test the track stop by pulling it toward the opposite track to ensure that it is locked in place.

To replace the rack:

1. Gently pull the tracks forward in dishwasher until they stop. Remove track stops. (See steps

1-3 above.)

2. Place the back wheels on each side of the rack into the track and roll the rack into the tracks,

butdo not push the rack all the way into the tub.

3. Insert front rack wheels on each side of the rack into the track.

4. Slide the rack into the dishwasher.

5. Replace the track stops by coming up from under the track and slipping the track stop into the

lower slot of the track (see Track stop - right) and rotate the track stop into place. Then press on

theedge of the ridged area while pushing the track stop straight toward the track. This action

locksthe retaining tab back into place.

6. Test the track stop by pulling it toward the opposite track to ensure that it is locked in place.

IMPORTANT: Be sure that the track stops are locked in place and cannot be easily removed. They

keep the rack from coming out of the track.

Track stop - left

Track stop - right

Loading ...

Use & Care Guide - Page 13