Loading ...
Loading ...
Loading ...
6
IMPORTANT: The sensor in your dishwasher monitors the soil level. Cycle time and/or water usage can vary as the sensor adjusts the
cycle for the best wash performance. If the incoming water is less than the recommended temperature or food soils are heavy, the cycle
will automatically compensate by adding time, heat and water as needed.
To run your dishwasher at
a later time or during off-
peak hours.
Delays the start of a cycle up to 6 hours.
Select a wash cycle and options. Press Delay. Press Start/
Cancel. Close the door firmly.
Heavy Wash, Normal
Wash, Light Wash, or
Auto Clean Plus cycles
Control Lock To avoid unintended use of
your dishwasher, or cycle
and option changes during
a cycle.
To turn on Lock, press and hold Heated Dry for at least
3 seconds.
To turn off Lock, press and hold Heated Dry for at least
3 seconds.
When Control Lock is lit, all buttons are disabled. If you press
any pad while your dishwasher is locked, the light flashes
5 times. The dishwasher door can be opened while the
controls are locked.
Anytime except when
dishwasher is running
OPTION SELECTIONS
OPTIONS DISH LOAD TYPES DESCRIPTIONS USE WITH:
CONTROLS AND
CYCLE STATUS
CONTROL PURPOSE COMMENTS
To start or resume a
wash cycle
If the door is opened during a cycle or the power is interrupted, the Start/Resume light will flash
to indicate a suspended cycle. The cycle will not resume until Start/Resume is pressed and the
door is closed within 3 seconds.
To change a cycle or setting prior to the start of wash, open the door slightly. The Start/Resume
light will flash. Select a new Cycle and/or options. Check the detergent dispensers. They must be
filled properly for the new cycle. Press Start/Resume. Close the door firmly until it latches.
To change a cycle or setting after the wash has begun, open the door slightly. The Start/Resume
light will flash. Press Cancel/Drain. The Cancel/Drain light glows. Close the door firmly until it
latches. Your dishwasher starts a 2-minute drain. Let the dishwasher drain completely. Select a
new Cycle and/or options. Check the detergent dispensers. They must be filled properly for the
new cycle. Press Start/Resume. Close the door firmly until it latches.
To cancel/drain a
cycle/options
To cancel a cycle, press cancel/drain. The cancel/drain light glows. The dishwasher starts a 2-
minute drain. Let the dishwasher drain completely. The light turns off after 2 minutes. The door
must be closed for the dishwasher to drain.
To stop the drain, press cancel/drain again to stop the drain. Remember to drain the dishwasher
before starting a new cycle.
To clear the indicators, press cancel/drain before starting the dishwasher to clear the options and
cycles.
To follow the
progress and status
of your dishwasher
cycle
Clean indicator glows when a cycle is finished.
If you select the Sanitize option, when the Sanitize cycle is finished, the Sanitized indicator glows.
If your dishwasher did not properly sanitize your dishes, the light will not come on. This can
happen if the cycle is interrupted, or the water could not be heated to the required temperature.
The clean and sanitize lights go off when the door has been opened for more than 30 seconds or
the CANCEL key is pressed.
Loading ...
Loading ...
Loading ...