Loading ...
Loading ...
Loading ...
6
For oor drain installations, you will need to remove the drain
hose form from the end of the drain hose. You may need
additional parts with separate directions. See “Tools and Parts”.
7. Remove drain hose form (oor drain
installations only)
CONNECT DRAIN HOSE
Remove the red plastic plug from the black drain port on the
back of the washer.
If clamp is not already in place on elbow end of drain hose, slide
it over end as shown. Squeeze clamp with pliers and slide black
elbow end of drain hose onto black drain port and secure with
clamp.
For a laundry tub or standpipe drain, go to step 6.
For a oor drain, remove the preinstalled drain hose form as
shown in Step 7. You may need additional parts with separate
directions. See “Tools and Parts”.
5. Attach drain hose to drain port
Place hose into standpipe (shown in picture) or over side of
laundry tub.
IMPORTANT: 114 mm (4.5") of drain hose should be inside
standpipe; do not force excess hose into standpipe or lay
on bottom of laundry tub. Drain hose form must be used.
6. Place drain hose in standpipe
114 mm
(4.5")
Drain
hose form
Remove tape from washer lid, open lid and remove cardboard
packing tray from tub. Be sure to remove all parts from tray.
NOTE: Keep tray in case you need to move washer later.
Firmly grasp power cord plug and pull to free from rear panel.
Gently place power cord over console to allow free access
to back of washer.
3. Remove packing tray from tub
4. Free power cord
Loading ...
Loading ...
Loading ...