JGCP436HL User Manual

Loading ...

Parts Supplied

Check that all parts are included.

■ Gas pressure regulator

■ Burner grates

■ Burner caps

■ Griddle drip tray (on griddle models)

■ Foam tape

Parts Needed

All models must be installed with a backsplash if installing at

zero clearance to a combustible back wall. See the “Cabinet

Dimensions” section in the “LocationRequirements” section for

installation requirements.

To order, see the “Assistance or Service” section of the Use

andCare Guide.

Check local codes and consult gas supplier. Check existing gas

supply and electrical supply. See the “Electrical Requirements”

and “Gas Supply Requirements” sections.

High Altitude Conversion

To convert the cooktop for elevations above 6,560 ft (2000 m),

order a High Altitude Conversion Kit.

■ Part Number W11238043: High altitude kit

NOTE: Both propane and natural gas conversions are included

in the high altitude kit.

To order, see the “Assistance or Service” section of the Use and

Care Guide.

NOTE: The cooktop is manufactured for use with Natural gas. To

convert to Propane gas, see the “Gas Conversions” section.

Location Requirements

IMPORTANT: Observe all governing codes and ordinances.

Donot obstruct ow of combustion and ventilation air.

■ It is the installer’s responsibility to comply with installation

clearances specied on the model/serial/rating plate. The

model/serial/rating plate is located on the underside of the

cooktop burner base.

■ It is recommended that a 600 CFM (17.0 m

/hr) or larger vent

hood beinstalled above the cooktop.

■ It is not recommended that a microwave hood combination

be mounted above the cooktop. Follow the range hood or

microwave hood combination installation instructions for

dimensional clearances above the cooktop surface.

■ The cooktop should be installed in a location away from

strong draft areas, such as windows, doors, and strong

heating vents or fans.

■ All openings in the wall or oor where cooktop is to be

installed must be sealed.

■ Cabinet opening dimensions that are shown must be used.

Given dimensions are minimum clearances.

■ Grounded electrical supply is required. See the “Electrical

Requirements” section.

■ Proper gas supply connection must be available. See the

“GasSupply Requirements” section.

■ The cooktop is designed to be supported by a solid oor in

the opening, not hung from the countertop by its side or rear

anges.

■ The gas and electric supply should be located as shown

inthe “Gas and Electric Connection Locations” section

sothat they are accessible without requiring removal of

thecooktop.

■ Provide cutout in left rear corner of cutout enclosure as

shown to provide clearance for gas inlet, power supply cord,

and to allow the rating label to be visible.

IMPORTANT: To avoid damage to your cabinets, check with

your builder or cabinet supplier to make sure that the materials

used will not discolor, delaminate, or sustain other damage.

Mobile Home - Additional Installation Requirements

The installation of this cooktop must conform to the

Manufactured Home Construction and Safety Standard,

Title24CFR, Part 3280 (formerly the Federal Standard for

Mobile Home Construction and Safety, Title 24, HUD Part

280).When such standard is not applicable, use the Standard

forManufactured Home Installations, ANSI A225.1/NFPA 501A

or local codes.

In Canada, the installation of this cooktop must conform with

thecurrent standards CAN/CSA-A240-latest edition or with

localcodes.

Loading ...

User Manual - Page 4