Loading ...
Loading ...
Loading ...
TO REMOVE DUST BAG:
Pull out on the
bag cover release Bag Cover
Release_
located near the
top of the bag Bag
cover, Cover-- I
\,tl
Grasp the dust bag /p_..J/).
collar and pull gently, .._ °
carefully removing the i "_
dust bag .J tl_,
Throw away the used i"ittl/"''
_t
dust bag. _./
Do not reuse,
Bag Holder
Pull the bag
cover forward
and lift up
Remove and lay
aside,
!m
Dust
Bag
Check the bag
holder and the
Bag Cavity motor safety fil-
ter, If either is
blocked, check
Safety TROUBLE-
Filter SHOOTING.
CAUTION
NEVER REUSE A DUST BAG. Very
fine materials, such as carpet fresh-
ener, face powder, fine dust, plaster,
soot, etc. can clog the bag and
cause it to burst before it is full.
Change bag more often when vacu-
uming these materials.
TO REPLACE DUST BAG:
Unfold the new
dust bag, Fold
the safety seal
tab on the new
dust bag away
from the open-
ing that fits on
the bag holder.
Dust
Bag
/
Safety
Seal Tab
NOTE: See PARTS AND FEATURES for
Bag #_
Insert the dust bag
onto the bag holder
completely by holding
the bag collar,
Place the dust bag
collar into position.
Tuck the bag
behind each of the
four bag retention
corner flaps shown
here. Be sure the
bottom and sides
of the dust bag are
completely within
bag cavity prior to
replacing the bag
cove r.
Slots [_"_C \
Retention _",_/
Corner__J
Flaps --" " "_.
Position the bag
cover so its posi-
tioning tabs fit
into the body
positioning tab
slots.
Close the bag
cover,
You wilt hear a
distinct snap
when cover is
securely closed,
Check to see that the dust bag is fully
enclosed in the bag cover,
15
Loading ...
Loading ...
Loading ...