Loading ...
Loading ...
Loading ...
CAUTION! Do not use the appliance
without filters.
Make sure that the filters are correctly
positioned. An incorrect positioning of
the filters will cause bad washing
results and damage to the appliance.
Dirty filters and a clogged spray arm
decrease the washing results.
Regularly check and if necessary,
clean the filters.
REMOVING AND CLEANING THE FILTERS
The filter consists of three parts.
A. Coarse filter
B. Fine filter
C. Main filter
A
B
C
1. Turn the fine filter (B) counterclockwise and
remove the filter assembly.
2. Remove the coarse filter (A) by pulling it out
from the fine filter (B).
3. Fully wash the filters with water and a brush.
4. Put the coarse filter (A) into the fine filter (B).
5. Put the filter assembly into the tub and turn the
fine filter (B) clockwise until it locks.
TO CLEAN THE SPRAY ARM
Do not remove the spray arm. If the holes in the
spray arm are clogged, remove remaining parts of
soil with a thin pointed object.
TO CLEAN THE EXTERNAL SURFACES
Clean the external surfaces of the appliance and
the control panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning
pads or solvents (e.g. acetone).
PROTECTING AGAINST FROST
Protect the appliance from frost, for example in
winter. After each cycle:
1. Disconnect the appliance from the electrical
supply.
2. Shut off water supply and disconnect the water
inlet pipe from the water valve.
3. Drain water from the inlet pipe and water valve.
4. Connect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and
use a sponge to collect water from the sump.
TROUBLESHOOTING
WARNING! Refer to Safety chapters.
WHAT TO DO IF...
If the appliance does not start or it stops during
operation, before you contact an Authorised
Service Centre, check if you can solve the problem
by yourself with the help of the information in the
table.
With some problems programme indicators flash
intermittently indicating a malfunction.
Problem and alarm code Possible solution
The appliance does not fill with water.
• The programme display shows E1.
• An intermittent acoustic signal sounds
for approximately 30 seconds.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is
not too low. For this information, contact your local
water authority.
• Make sure that the water tap is not clogged.
11
Loading ...
Loading ...
Loading ...