Loading ...
Loading ...
Loading ...
5. If the indicator light on the HomeLinkT blinks
rapidly for 2 seconds and then turns solid,
HomeLinkT has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train the
HomeLinkT to complete the programming
which may require a ladder and another per-
son for convenience.
6. Press and release the “smart” or “learn” pro-
gram button located on the garage door
opener’s motor to activate the “training
mode”. This button is usually located near
the antenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the lens to
access the program button.
NOTE:
Once you have pressed and released the
program button on the garage door open-
er’s motor and the “training light” is lit, you
have 30 seconds in which to perform step 7.
Use the help of a second person for conve-
nience to assist when performing this step.
7. Within 30 seconds of pressing and releas-
ing the garage door opener program button,
quickly and firmly press and release the
HomeLinkT button you’ve just programmed.
Press and release the HomeLinkT button up
to 3 times to complete the training.
8. Your HomeLinkT button should now be pro-
grammed. (To program the remaining
HomeLinkT buttons for additional door or
gate openers, follow steps 2-8 only.)
NOTE:
Do not repeat step 1 unless you want to
“clear” all previously programmed
HomeLinkT buttons.
If you have any questions or are having difficulty
programming your HomeLinkT buttons, refer to
the HomeLinkT web site at: www.homelink.com
or call 1-800-355-3515.
PROGRAMMING HOMELINKT FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required hand-
held transmitters to stop transmitting after 2 sec-
onds. To program your hand-held transmitter to
HomeLinkT, continue to press and hold the
HomeLinkT button (note steps2-4under “Pro-
gramming HomeLinkT”) while you press and re-
press (“cycle”) your hand-held transmitters every
2 seconds until the indicator light flashes rapidly
(indicating successful programming).
NOTE:
When programming a garage door opener,
etc., it is advised to unplug the device dur-
ing the “cycling” process to prevent pos-
sible damage to the garage door opener
components.
Type B
LIC0677
2-52 Instruments and controls
Z REVIEW COPY—
2005 Titan (tzw)
Owners Manual—USA_English (nna)
02/26/05—tbrooks
X
Loading ...
Loading ...
Loading ...