Loading ...
Loading ...
Loading ...
4
NOTE
The exterior walls of the wine cooler may
become quite warm as the compressor
works to transfer heat from the inside.
Temperatures as much as 30° F warmer
than room temperature can be expected.
For this reason it is particularly important in
hotter climates to allow enough space for air
circulation around your wine cooler.
Leveling
The wine cooler must have all bottom corners
resting rmly on solid oor. The oor must be
strong enough to support a fully loaded wine
cooler. NOTE: It is Very Important for your
wine cooler to be level in order to function
properly. If the wine cooler is not leveled
during installation, the door may be misaligned
and not close or seal properly, causing cooling,
frost, or moisture problems.
To Level Your Wine Cooler:
After removing all interior and exterior
packaging materials, use a carpenter’s level to
level the wine cooler from front-to-back. Adjust
the leveling legs in front, ½ bubble higher, so
that the door closes easily when left halfway
open.
Cleaning
• Wash any removable parts of the wine
cooler interior, and exterior with mild
detergent and warm water. Wipe dry. Do
not use harsh cleaners on these surfaces.
• Do not use razor blades or other sharp
instruments, which can scratch the
appliance surface when removing adhesive
labels. Any glue left from the tape can be
removed with a mixture of warm water and
mild detergent, or touch the residue with
the sticky side of tape already removed. Do
not remove the serial plate.
Important Safeguards: Do not store food in
your wine cooler as interior temperature may
not get cool enough to prevent spoilage. In
summer months or areas of high humidity, the
glass door may build up moisture. To remove
the moisture, wipe it away.
Handle Installation
1. Place the handle over the two mounting
screws at top of door.
2. Tighten the two set screws in bottom of
handle using Allen wrench.
Upper Trim Panel Installation
If the unit is being installed in an existing cut-
out, the optional trim panel can be attached to
top of unit to ll any remaining gap. Use the
two screws that are pre-assembled in top of
cabinet to attach trim panel as shown below.
Handle Mounting Screws
Set Handle
Wrench
TightenLoose
Turn
clockwise
to
tighten
Screws (2 pcs)
INSTALLATION
This Use & Care Guide provides general
operating instructions for your model. Use the
appliance only as instructed in this Use & Care
Guide. Before starting the wine cooler, follow
these important rst steps.
Location
• Choose a place that is near a grounded
electrical outlet. Do Not use an extension
cord or an adapter plug.
• For optimal performance, it is
recommended that you install the wine
cooler where the ambient temperature is
between 70 and 78 degrees fahrenheit.
• Allow space around the unit for good air
circulation. Leave a 2 inch space on the
back and sides of the wine cooler for
adequate circulation.
• Be sure the wine cooler stays in the upright
position during transport.
• Keep the wine cooler from any hazardous
or combustible agents.
Loading ...
Loading ...
Loading ...