Loading ...
Loading ...
Loading ...
9
EN
Timer / delayed start
If the appliance is on: you can use this button to define the operating duration. Briefly press the button to select
the number of operating hours desired (1, 2, 4 or 8) and the appliance will automatically turn off at the end of
the selected period.
If the appliance is off: briefly press the button to set the appliance to turn on in a certain number of hours (1,
2, 4 or 8).
3D pure air function (adjustable grid)
You can adjust the position of the air outlet grid manually, as desired. For an optimum, even flow of purified air
in the room, set the angle to 45°; for maximum comfort, set the angle to 90°.
Control Panel Lock
The lock system prevents the purifier from being accidentally mis-set during operation.
To activate it, press the button (8) for 3 sec until the locked control panel indicator turns on. To exit this mode,
press the button (8) again for 3 seconds, until the indicator turns off. When selected, the other buttons are locked.
MAINTENANCE
Always switch the appliance off with the button (10) and unplug it before conducting any maintenance
operation.
You can clean the appliance with a slightly damp cloth.
IMPORTANT: Never use abrasive products which could damage your appliance’s appearance.
Filters
Filter Action Cycles
Pre-filter Clean Every 2 to 4 weeks
Active carbon filter Replace Every 12 months
Allergy + filter Replace Every 3 years
NanoCaptur filter Replace
Color changing
(see Color chart on filter)
This data is based on an average use of 8 hours per day at speed 2.
The recommended frequency for cleaning and replacing the filters may vary depending on the duration of use
and the operating environment.
- The light indicates when the pre-filter needs cleaning.
- The light indicates when the active carbon filter needs replacing.
- The light indicates when the ALLERGY+ FILTER needs replacing.
- The light indicates when the color of the NanoCaptur filter needs checking.
• The NanoCaptur lter contains translucent granules which change color according to the formaldehyde ab-
sorption rate. Refer to the color chart on the inside of the panel or the lter itself to establish the lter satu-
ration rate. Once the saturation rate has reached its maximum, the lter must be replaced. You have to check
the lter saturation rate every six months.
• The pre-lter can be re-used: remove the dust using a vacuum cleaner or wash with water.
CAUTION:
The appliance’s efficiency can be reduced if the pre-filter is not cleaned regularly.
Never use a pre-filter that is still damp.
The pre-filter is the only filter which can be re-used and washed with water. The ALLERGY+ FILTER,
NanoCaptur and active carbon filters cannot be cleaned and re-used. Never wash with water.
To replace the filters, follow the instructions in the section “Disassembling/Reassembling filters” .
Loading ...
Loading ...
Loading ...