Loading ...
Loading ...
Loading ...
29
Correcting keystone
Keystoning refers to the situation where the projected image becomes a trapezoid due to
angled projection.
To correct this, besides adjusting the height of the projector, you will need to manually
correct it following one of these steps.
• Using the remote control
1. Press / to display the Keystone
correction page.
2. Press to correct keystoning at the top of
the image. Press to correct keystoning at
the bottom of the image.
• Using the OSD menu
1. Open the OSD menu and go to the
DISPLAY > Keystone > Manual menu.
2. Press Enter.
3. Press to correct keystoning at the top of the image or press to correct
keystoning at the bottom of the image.
The projector can automatically correct vertical keystone. To do this, open the OSD menu
and go to the
DISPLAY > Keystone > Auto V Keystone and press / to select On.
Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
• Using the remote control
1. Press on the remote control to display the Zoom bar.
2. Press repeatedly to magnify the picture to a desired size.
3. To navigate the picture, press Enter to switch to the paning mode and press the
directional arrows ( , , , ) to navigate the picture.
4. To reduce size of the picture, you can press Auto Sync on the remote control to
restore the picture to its original size. Or you can press Enter to switch back to the
zoom in/out functionality and press .
• Using the OSD menu
1. Open the OSD menu and go to the
DISPLAY > Zoom menu.
2. Press Enter. The Zoom bar is displayed.
3. Repeat steps 2-4 in the section of Using the remote control above.
This adjustable range may vary depending on different aspect ratios.
The picture can only be navigated after it is magnified. You can further magnify the picture
while searching for details.
Press /
Press /
Loading ...
Loading ...
Loading ...