EBF46S User Manual

Loading ...

User Manual 06

will ensure that valuable raw materials can be

recovered and used again.

2. The refrigerant used in your appliance and

insulation materials require special disposal

procedures. Ensure that none of the pipes on the

back of the appliance are damaged prior to

disposal. Up to date information concerning

options for disposing of your old appliance and

packaging from the new one can be obtained from

your local council office.

Instructions for Use

1.When operating the refrigerator for the first time,

run it without loading any food until it autos

tops at the desired temperature. Usually it takes

2 or 3hours,then set the thermostatic dial at the

setting desired and put foods in the refrigerator.

2.The temperature of the refrigerator can be

adjusted by turning the thermostatic dial. A

medium setting of the thermostatic dial is the

most suitable for general operation.

Instruction, Maintenance

3.Defrost the freezing compartment whenever the

layer of frost on the surface of the evaporator

reaches 3 or 4 mm. When defrosting remove all

food and set the thermostat at “OFF” position.

Put the drip tray under the evaporator to collect

melted water. After the frost has melted, discard

the melted water and dry up the interior of

refrigerator. The refrigerator can then be

restarted by turning its thermostat to the desired

setting.

Cautions for Use

1.The more foods tuff put in or the more and the

longer for once the door is opened, the more it

needs electric consumption, which even leads

malfunction.

2.Better not to place the objects which are too

heavy ,pointed or corrosion on table board.

3.Re-plugging in the power plug at the interval of

over ten minutes.

4.Don’t store bottled drink in the freezer, so as to

prevent from being broken and damaging the

refrigerator.

5.Open the door as less as possible during

power-cut.

6.When defrosting, never use any sharp or metallic

objects to remove the frost on the surface of the

evaporator as it will damage the evaporator.

7.Don’t touch foods and containers in the freezing

temperature of the two compartments is higher

while the refrigerator is operating, it takes some

times for the temperature of the two

compartments to become cold. If the

environmental temperature is higher, it takes a

long time to make the compartments to become

cold.

4.The surface of the compressor becomes hot:

The surface of the compressor may become hot

under normal operation. Don’t touch it with

hands.

Methods of inspecting malfunction

If any case of malfunction happens, please

inspect and dispel it according to the methods

shown in the following table.

case

Inspection

Not

refrigerating

Is there no electric current?

Is the voltage normal or not?

Has the socket fused?

Has the plug been put in

effectively?

compartment with your wet hands so as to

prevent from being frostbitten.

Maintenance

1.While cleaning the refrigerator. pull out the

electric power plug, rub carefully with a piece of

cloth soaked with natural cleanser then wipe

with clean water. The abrasive cleaning power,

alkali cleansers, chemical cloth, thinner, alcohol,

acid petroleum product and hot water are not

suitable for cleaning the refrigerator, they may

damage the painting cover and plastics.

2.The door gasket is dirty and fogged easily, so

clean it frequently.

3.If the refrigerator is out of use for a long time,

please pull out the plug, clean and dry the

freezing compartment then close the door

tightly.

The following cases are not malfunction

1.A flowing water sound:

Flowing water sound will be heard under normal

operation.

2.Outside condensation:

Outside condensation is normal in high humidity

condition. You may just wipe it up yourself.

3.It takes some times for the temperature of the

freezer and refrigerator compartments to become

cold after the refrigerator starts to operate: If the