Loading ...
Loading ...
Loading ...
8
2. Use a flat head screwdriver to adjust the leveling
screws (see Figure A), turning clockwise to raise the
side of the refrigerator and counter-clockwise to lower
it. It may take several turns to adjust it to the inclination
you would like.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws.
This will make it easier to adjust the screws.
3. Open both doors again and check to make sure that
they close easily. If not, tilt the refrigerator slightly more
to the rear by turning both leveling screws clockwise. It
may take several more turns, and you should turn both
leveling screws the same amount.
DOOR ALIGNMENT
If the space between your doors is uneven, follow the
instructions below to align the doors:
1. Using the Phillips screwdriver, loose the screw from the
top-hinge cover, after this remove it with a flat head
screwdriver.
2. Loosen the top hinge bolts using a 10 mm or 13/32
inch socket wrench or open-end wrench.
3. Have someone hold the freezer door so the space
between the two doors is even, and retighten the top
hinge bolts.
4. Replace the top hinge cover.
HOW TO REMOVE AND INSTALL THE
REFRIGERATOR DOORS
If entrance is lees than 32 inches (82 cm) wide, the
refrigerator’s door will need to be removed.
IMPORTANT: Before starting, turn off and unplug the
refrigerator. Remove all food and the racks from the
doors.
TOOLS YOU MIGHT NEED OR USE
10 mm
13/32 in
3/8 in
Hex Socket Wrench Phillips Screwdriver
No. 2
Flat Head Screwdriver
WARNING
ELECTRICAL SHOCK HAZARD
Before you begin, either unplug the refrigerator or
turn off the power at the circuit breaker or fuse box.
Remove food and any door rack from the refrigerator.
Failure to do so could result in death or serious injury.
1. Removing the Freezer Door
•Using the Phillips screwdriver, loose the screw from the
top-hinge cover (a) after this remove it with a flat head
screwdriver (b) (See Fig. 1).
•Using either a 10 mm or 13/32 in. socket wrench,
remove the three bolts and lift off the top hinge. Set
parts aside (See Fig. 2).
•Carefully lift up the freezer door. Place the door on a
non-scratching surface.
2. Removing the Refrigerator Door
• Loosen and remove the two bolts using the socket
wrench (See Figure 4).
REFRIGERATOR INSTALLATION
Fig. 3
Fig. 4
Middle Hinge
Bracket
Fig. 2
Fig. 1
(a)
(b)
Screw
Loading ...
Loading ...
Loading ...