Loading ...
Loading ...
Loading ...
4. Attach the hook to the outboard tether strap loop (see diagram). Tighten the tether
strap according to the child seat manufacturer’s instructions.
Installing Three Child Restraints:
1. Place a child restraint on each out-
board rear seat. Route the tether
straps following the directions for
right and left seating positions, above.
2. Attach both hooks to the center tether
strap loop, but do not tighten the
straps yet.
3. Place a child restraint on the center
rear seat. Route the tether strap fol-
lowing the directions for the center
seating position, above.
4. Attach the hook to the outboard tether
strap loop.
5. Tighten the tether straps according to the child seat manufacturer’s instructions,
tightening the right and left tether straps before the center tether strap.
Installing The Child Restraint Using The Vehicle Seat Belts
• To install a child restraint, first, pull enough of the seat belt webbing from the
retractor to route it through the belt path of the child restraint and slide the latch
plate into the buckle.
• Next, extract all the seat belt webbing out of the retractor and then allow the belt
to retract into the retractor. Finally, pull on any excess webbing to tighten the lap
portion around the child restraint. Any seat belt system will loosen with time, so
check the belt occasionally, and pull it tight if necessary.
• Route the tether strap to provide the most direct path for the strap between the
anchor and the child seat, preferably between the head restraint posts underneath
the head restraint.
Tether Strap Through Center Tether Strap Loop
And Attached To Outboard Tether Strap Loop
Left Outboard And Center Seating Position
Shown
GETTING STARTED
19
Loading ...
Loading ...
Loading ...