Loading ...
Loading ...
Loading ...
16
COPY SETTINGS
This section explains the administrator settings that are used for copy mode.
Copy settings
"Copy settings" consists of the following settings:
● Initial status settings
● Exposure adjustment
● Rotation copy setting
● Add or change extra preset ratios
● 600dpi x 600dpi scanning mode for document
feeder
● Quick scan from document glass
● Initial margin shift setting
● Erase width adjustment
*1
● Card shot settings
*1
● Setting a maximum number of copies
● Disabling deletion of job programs
●
Disabling of bypass-tray in duplex copy
● Disabling of auto paper selection
*1 Default settings selected with these settings apply
to all functions of the machine (not just the copy
function).
Initial status settings
The copy settings revert to the default settings when
the power switch is turned on, when the [CA] key is
pressed, or when the auto clear time elapses. This
setting is used to change the default settings, or return
changed default settings to the initial factory default
settings.
Defaults for the following copy settings can be
changed:
Paper tray/Exposure tray/Copy ratio/2-sided copy/Out
put (auto, sort, staple sort, group, output tray)
Exposure adjustment
This setting is used to adjust the exposure level when
"Auto" is used for the copy exposure.
The factory setting is "5". "1" indicates lighter density
and "9" indicates darker density on the touch panel.
Rotation copy setting
This setting is used to have the image of an original
automatically rotated when the orientation of the
original does not match the orientation of the copy
paper.
(Rotation copy will function only if the auto paper select
or auto image mode has been selected.)
Add or change extra preset ratios
When using inch sizes, there are normally four preset
enlargement ratios and four preset reduction ratios.
When using AB sizes, there are normally five preset
enlargement ratios and five preset reduction ratios.
This
setting
allows you to add two more preset
enlargement ratios and two more preset reduction ratios.
This
setting
also allows you to change a preset ratio.
600dpi x 600dpi scanning mode for document
feeder
Use this setting to change the original scanning
resolution of the automatic document feeder from 600
x 300 dpi to 600 x 600 dpi.
If this mode is set, the copy quality for fine characters
and fine lines will be improved but the original scanning
speed will be slower.
Quick scan from document glass
Use this setting to change the original scanning
resolution on the document glass from 600 x 600dpi to
600 x 300 dpi.
When this setting is enabled, the first copy time will be
shorter, however, copy images will be slightly coarser.
NOTE
If this setting is used to change the default setting for
the duplex function to other than "one-sided"
"one-sided" and the automatic document feeder fails
or is disabled*, the setting will revert to "one-sided"
"one-sided".
* DISABLING OF DOCUMENT FEEDER (page 11)
DISABLING OF DUPLEX (page 11)
NOTE
To copy an 5-1/2" x 8-1/2" or A5 size original onto
5-1/2" x 8-1/2"R or A5R paper, this setting must be
enabled.
NOTE
Only an added preset ratio can be changed.
NOTE
If you prefer a quicker scanning speed over higher
resolution, do not enable this setting.
NOTE
If you prefer a higher quality copy image over a
shorter first copy time, do not enable this setting.
JupiterII_Admin_sec.book 16 ページ ２００６年１２月１２日 火曜日 午後５時３９分
Loading ...
Loading ...
Loading ...