Loading ...
Loading ...
Loading ...
aus Fault, what to do?
30
Removable streaks on
glasses, glasses with
metallic appearance and
cutlery.
Too much rinse aid. Set rinse aid amount to lower setting.
No rinse aid added or setting too
low.
Add rinse aid and check dosage
(recommended setting 4-5).
Detergent residue in the final
rinse programme section.
Detergent dispenser cover
blocked by utensils (cover does
not open fully).
Detergent dispenser cover must not be
obstructed by utensils.
Do not place utensils or fragrance dispenser
in the tablet collecting tray.
Utensils precleaned too intensely;
sensors therefore decide on
weak programme sequence.
Stubborn soiling cannot be
completely removed.
Do not prerinse utensils. Remove only large
food remnants.
Initial or existing,
irreversible clouding
of glass.
Glasses not dishwasher-proof,
only suitable for dishwasher.
Use dishwasher-proof glasses.
Avoid long steam phase (standing time after
wash cycle ends).
Use wash cycle at lower temperature.
Use detergent with glass protection
component.
Rust spots on the cutlery. Cutlery not adequately rust-
resistant. Knife blades are
frequently more severely
affected.
Use corrosion-resistant cutlery.
Cutlery will also rust if rusting
parts are rinsed at the same time
(pan handles, damaged utensil
baskets, etc.).
Do not wash rusting parts.
The appliance does not
start.
The mains fuse has tripped. Check mains fuse.
Power cord not inserted. Ensure that the power cord is plugged all
the way into the back of the appliance and
into the socket. Check that the socket
functions.
The appliance door has not been
shut properly.
Close the door.
Programme starts
automatically.
You did not wait until programme
ended.
Perform reset.
(See Terminating the programme).
The door is difficult
to open.
Child-proof lock is activated. Deactivate childproof lock. (See instructions
for use at the back)
Door cannot be closed. Door lock has been activated. Close door with increased force.
Door cannot be closed due to
installation.
Check appliance installation: Door or
attached parts must close without
obstruction.
Fault Cause Remedial action
Loading ...
Loading ...
Loading ...