Frigidaire FFAD6022W1 High Humidity 60 Pint Capacity Dehumidifier

Use & Care - Page 13

For FFAD6022W1.

PDF File Manual, 15 pages, Read Online | Download pdf file

FFAD6022W1 photo
Loading ...
Loading ...
Loading ...
13BEFORE YOU CALL
Fan noise.
• Air is moving through the dehumidifier. This is a normal sound.
Frost appears on coils
behind the filter
• Dehumidifier has been turned on recently. This is normal due to refrigerant
rushing through the coil. Frost will usually disappear within 60 minutes.
• Room Temperature is too low. All models will operate satisfactorily at
temperatures greater than 41 °F (5 °C).
Dehumidifier is
operating but room is
not dry enough.
• Humidity setting is too high. Press the HUMIDITY button or rotate knob to a
lower setting or choose CONTINUOUS for maximum dryness.
• Dehumidifier has been installed or restarted recently. The higher the
moisture in the room air, the longer it takes for the room air to become dry.
• Dehumidifier does not have sufficient clearance to operate. Air flow to the
air outlet is blocked. See “Selecting a Location”.
• Room temperature is too low. Unit will not operate satisfactorily if the
room temperature is below 41 °F(5 °C). See “Operating Conditions”.
• Refer to causes under DEHUMlDIFIER RUNS TOO MUCH.
Before calling for service, review this list. It may save you time and expense. This list
includes common occurrences that are not the result of defective workmanship or materials
in this appliance.
SOLUTIONOCCURRENCE
Dehumidifier does not
operate.
• Wall plug disconnected. Push plug firmly into wall outlet.
• House fuse blown or circuit breaker tripped. Replace fuse with time delay
type or reset circuit breaker.
• The dryness level you selected has been reached. Dehumidifier automati-
cally shuts o when selected amount of moisture has been removed from
the air. If you want to remove more moisture, Select 'CONTINUOUS' by
using the humidity button or knob. After the dehumidifier starts, reset the
control to the desired setting.
• Bucket not installed properly. See “Removing Collected Water“.
• Water in the bucket has reached its preset level. Dehumidifier automatically
turns o when this occurs. Empty bucket and return bucket to position.
• Dehumidifier is not turned on. Turn unit on.
• “BUCKET FULL“ light is on. Remove bucket, empty water and re-install
correctly.
Dehumidifier runs too
much.
• Windows or doors near dehumidifier are open to outdoors. Close all
windows or doors to outside.
• Area to be dehumidified is too large. Check with your dealer to see if
capacity is adequate.
• Air movement through dehumidifier is blocked. Grill may be dirty. Use brush
attachment of vacuum cleaner to clean grill. See “Care and Cleaning“.
Dehumidifier must be placed in a space that does not restrict air flowing into
the rear coil or out of the front grill.
• Dehumidifier has been installed or restarted recently. The higher the
moistuire in the room, the longer the dehumidifier will operate.
• Dehumidifier is in the CONTINUOUS mode and will remain on in this mode,
use the humidity button or knob to set a RH% higher level.
If These Solutions Fail, Call 1-800-944-9044(US)/1-800-265-8352(Canada)
For Frigidaire Service.
Loading ...
Loading ...