Loading ...
Loading ...
Loading ...
Initial operation 7
3 Initial operation
Placement
Place the projector on a flat surface in front of
the projection surface.
Connecting power supply
The projector can be operated by either
external power or built-in battery.
CAUTION!
Always use the button to turn the
projector on and off.
Operation by external power
• Using the supplied USB cable, connect the
port on the projector to the supplied
power adapter. Then connect the power
adapter to the wall outlet.
If needed, select an appropriate power plug
adapter (EU, UK, US) for connecting to the
wall outlet.
a
b
c
• Or, simply using the supplied USB cable,
connect the USB port on the projector to
a USB port on your computer or a power
bank.
Operation by built-in battery
The projector can be also operated on built-in
battery for portability.
Charging projector
Charge the projector for 1.5 hours before first
use.
Charge the projector when the low battery
icon appears in the center of of the projection
screen.
• To charge the projector, connect the
projector to an external power supply as
described in the section of “Operation by
external power”.
• When charging, the LED on the projector
turns red. When fully charged, the red LED
turns off.
Notice
The capacity of the built-in battery
diminishes with time. If the projector
functions only with external power
supply, the built-in battery is defective.
Contact an authorised service centre to
replace the built-in battery.
Preparing the remote
control
CAUTION!
The improper use of batteries can lead
to overheating, explosion, risk of fire and
injury. Leaking batteries can possibly
damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or charging
the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1 Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/- ) indicated.
3 Close the battery compartment.
Notice
When using the remote control, point the
remote control at the IR sensor located
on the back of the projector, and make
sure there is no obstacle between the
remote control and the IR sensor.
Power on and setup
1 Press and hold on the projector for
3 seconds (or on the remote control for
1 second) to switch the projector on or off.
• When the projector is switched on, the
LED on the projector turns blue if the
projector is not being charged.
• When charging, the LED on the
projector turns red regardless of the
projector switching on and off.
Loading ...
Loading ...
Loading ...