Loading ...
Loading ...
Loading ...
CARE GUIDE
Note: If the valves must be replaced, first disassemble the ignition
switches wires.
It is recommended to replace the valve gaskets each time the valve
is replaced, thus ensuring a perfect seal between the body and the
gas manifold.
WARNING: Disconnect power before servicing unit.
For the location of the wall receptacle for the three-prong grounded
plug of the appliance, see Fig. 1- 2.
WARNING: After first installation of the appliance or after any service
intervention concerning main gas parts of the appliance, perform
leak test using water with soap on the gas connections in order to
verify proper installation. Do not use fire for gas leak testing.
GREASING THE VALVES
If it becomes difficult to operate the valve, it should be greased
immediately by following the steps below:
1. Disassemble the valve body by loosening the two screws located
on the body of the valve. (See Fig. 13).
2. Extract and clean the seal cone and its housing with a rag soaked
with thinners.
3. Lightly grease the cone with a special grease.
4. Insert the cone, moving it several times, remove it again, remove
the excess grease and make sure that the gas passage ways
are unobstructed.
5. Replace all the pieces in reverse order and check that the valve o
perates correctly.
16
Loading ...
Loading ...
Loading ...