Loading ...
Loading ...
Loading ...
EN
9
9
Installing of the chimney and fixing of the hood
When the hood is installed in recycling version the chim-
ney has to be positioned with the slots upwards. When
the hood is installed in ducting version it has to be posi-
tioned in the opposite way.
• Place the chimney on the frame and fix it to the upper
part of it with the earlier removed screws. When in-
stalling the hood in recycling version make sure that
the slots correspond to the air outlet of the recycling air
outlet piece 15.
• Open the lighting unit by slightly pulling the notch.
Remove the unit from the hood by sliding the fixing
pivot.
• Remove the filter pushing it towards the back side of
the hood unit and simultaneously pulling downwards.
• Remove possible charcoal filters.
• In order to fix the hood body to the frame insert the 4
screws 12f in their seats. It is necessary to leave at
least 4-5 mm gap between the screw heads and the
frame plate.
• Hook the hood canopy to the frame and turn it to the
left until it reaches the stop, then lock the screws im-
mediately to prevent the hood canopy from falling out
accidentally.
2
1
ELECTRICAL CONNECTION
• Connect the Hood to the mains power supply, inserting
a two-pole cut-out switch with contact aperture of at
least 3 mm along the line.
• Ensure that the supply cable connector is properly in-
serted into the Suction device socket
• Hook up the Commands connector Cmd.
• Hook up the Spotlights connector Lux to the socket
provided behind the lighting unit cover.
• For the Recirculation Version, fit the Activated Char-
coal Odour Filter.
• Replace the filters and the lighting unit.
Cmd
Lux
Loading ...
Loading ...
Loading ...