Loading ...
Loading ...
Loading ...
28
CD-DP900S(E)3.fm03/11/28
CD-DP900S
TINSEA032AWZZ
Advanced Features/References
- Enhancing your system / Troubleshooting chart -
Enhancing your system
The connection lead is not included. Purchase a commercially available lead as shown below.
!
Listening to the playback sounds from
VCR, DVD, etc.
Note:
To prevent hum interference, place this unit away from a television.
!
To record on a tape
Troubleshooting chart
Many potential problems can be resolved by the owner without calling a service tech-
nician.
If something is wrong with this product, check the following before calling your
authorised SHARP dealer or service centre.
!
General
!
CD player
!
Tuner
1
Use a connection lead to connect the VCR, DVD, etc. to the VIDEO/
AUX IN sockets.
When using video equipment, connect the audio output to this unit and the video
output to a television.
2 Press the ON/STAND-BY button to turn the power on.
3 Press the VIDEO/AUX button.
4 Play the connected equipment.
1 Insert a cassette in the TAPE 2 cassette compartment.
2 Press the VIDEO/AUX button.
3 Press the REC PAUSE ( ) button.
4 Press the / (TAPE 2 ) button.
5 Play the VCR, DVD, etc.
VCR, DVD, etc.
To the line
output sockets
Red
RCA lead
(not supplied)
White
Red White
Symptom Possible cause
" The clock is not on time. " Did a power failure occur? Reset the
clock. (Refer to page 15.)
" When a button is pressed, the unit
does not respond.
" Set this unit to the power stand-by mode
and then turn it back on.
" If the unit still malfunctions, reset it. (Refer
to page 29.)
" No sound is heard. " Is the volume level set to "0"?
" Are the headphones connected?
" Are the speaker wires disconnected?
Symptom Possible cause
" Playback does not start. " Is the disc loaded upside down?
" Playback stops in the middle or is
not performed properly.
" Does the disc satisfy the standards?
" Is the disc distorted or scratched?
" Playback sounds are skipped, or
stopped in the middle of a track.
" Is the unit located near excessive vibra-
tions?
" Is the disc very dirty?
" Has condensation formed inside the unit?
Symptom Possible cause
" Radio makes unusual noise con-
secutively.
" Is the unit placed near the TV or compu-
ter?
" Is the FM aerial or AM loop aerial placed
properly? Move the AC power lead or the
unit away from the aerial if located near.
Downloaded from: http://www.usersmanualguide.com/
Loading ...
Loading ...
Loading ...