Loading ...
Loading ...
Loading ...
www.napoleongrills.com
5
WARNING!
WARNING!
WARNING!
BUILT IN : The piping up to the gas grill is the
responsibility of the installer and piping should be located as shown in the built-in instrucons. A exible
metal connector is included to simplify the installaon of the unit. Connect this exible metal connector
to the are ng on the end of the manifold. Connect the other end of the connector to the gas piping.
Ensure that the connector does not pass through a wall, oor, ceiling or paron, and is protected from
damage. The installaon must be performed by a licensed gas er in accordance with AS5601 / AG601,
and all connecons must be leak tested before operang the grill.
Do not use a hose to connect the unit except to connect the cylinder regulator to the piping system. It
must be connected with rigid pipe, copper tube or an approved exible metal connector which complies
with with AS5601 / AG601. The gas supply pipe must be suciently sized to supply the kPA specied on
the rang plate, based on the length of the piping run. If installing a side burner, a separate line must be
branched o to the side burner unit and enter the side burner opening at the specied locaon. If the
enclosure is to house a ULPG cylinder, the tank poron of the enclosure must be venlated according
to local codes, and must not have communicaon with the cavity used to enclose the gas grill. A ULPG
cylinder cannot be stored below the gas grill.
This gas grill is cered for outdoor use and should be installed to conform to local codes. Check gas type
and specicaons located on the rang plate located on the back panel of the grill.
Universal Liqueed Petroleum Gas Cylinder Specicaons
WARNING!
If the gas grill is being supplied with Universal Liqueed Petroleum Gas from a portable cylinder, a
regulator specied by the manufacturer must be used. Cart models have been designed for use for use
with an approved 9 kg size Universal Liqueed Petroleum Gas cylinder (not supplied). The Universal
Liqueed Petroleum Gas cylinder must be equipped with a POL tank valve connecon. A dented or rusty
cylinder may be hazardous and should be checked by your Universal Liqueed Petroleum Gas supplier.
Never use a cylinder with a damaged valve. The cylinder supply system must be arranged for vapor
withdrawal and the cylinder shall include a dust cap to protect the cylinder valve. The cylinder shall
incorporate a listed OPD (overll protecon device). Do not store a spare Universal Liqueed Petroleum
Gas cylinder under or near this appliance. Never ll the cylinder beyond 80 percent full.
Loading ...
Loading ...
Loading ...