Loading ...
Loading ...
Loading ...
Choosetheproperwindowlocation.
Chooseawindowthatallowsthecooledairtoflowfreelyanddirectly
intoroom(s)youwishtocool.Remember,itisdifficulttomoveair
aroundcorners.Also,chooseawindowthatiswithin6feetofan
electricaloutletasshown(FIG.5).(SeeMeetingElectrical
Requirements/Receptaclewiringneeds.)Donotuseanextensioncord.
ii!i!i!i!i!i!i!i!i!i!J;!_i_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_i;_!_!_i_i_i_i_iiii!iiiiiiiii.....
Installing Unit in a Sliding Window:
_ Attach support brace to platform as shown (FIG.6). Use adjustment
bolt and hex flange nut to complete assembly. Choose slot and adjustment
bolt hole locations that will create a 45 degree angle between platform and
support brace. Try assembly in the window to determine if platform will rest
properly, and allow proper slope (3/16" lower on out side).
FIG.5
FIG.6
PlatformAssembly
• If you are planning to use a siding-protection board (see Step 8)
on the outside of your house hold board in place when testing
assembly in window.
ii
_ Measure, and lightly mark a line 8=11/16" from window jamb:
1/4" (dmm)HEX
FLANGE NUT
--... ®
8-11/16" inches FIG.7
If any sash stop protrudes more than 1 from the side window
jambs, the 8-11/16" measurement must be increased
accordingly (FIG.7). Screen and storm window frames may also
require adjustments to the measurement.
_ Center platform assembly on the line with inside platform tab
pressed against inside edge of window track as shown (FIG.8A, FIG.8B).
Using the holes in the platform as a guide, mark and drill two 9/64" diameter
holes. Drill holes in either track or stool.
_Peel off protective backing from track seal. Apply seal to room side
of window track (FIG.9). Center of seal strip should coincide with the line
marked in Step 5. The two screw holes drilled in Step 6 should be directly
above seal strip in the inner track.
_ Securely attach a siding=protection board to side of house (FIG.10).
NOTE: Siding-protection board should be long enough to span 2 wall studs.
Alternate screw location
(depending on the inner sill depth)
window track window seal
FIG.9
Apply track seal
to window side
of track. _
?
/
J
FIG.8A
Center platform
assembly on the line
with platform tab pressed
against window track
FIG.IO
,j_ Sid2_g-protection
Loading ...
Loading ...
Loading ...