Loading ...
Loading ...
Loading ...
10
Power Failure
ALARM RESET
Temp
Minus
keypad
Temp
Plus
keypad
On/Off
keypad
Display Area
Lock
keypad
System Status
indicators
Figure 12
Electronic single zone control
Starting your appliance:
Plug the appliance power cord into a 115 volt wall outlet.
Your appliance is shipped from the factory in the "On"
position and will begin start-up of cooling as soon as power
is supplied. If the appliance does not start, confi rm that the
wall outlet has power, and that the control is in the "On"
position, (See "Turning your appliance On and Off" below).
The control display is covered with a clear plastic fi lm. This
fi lm may be removed by carefully lifting the fi lm at a corner.
On initial power up, the control display will indicate a
"Power Failure" alarm. This is a normal condition as
the appliance was powered-up at the factory for quality
inspection and then removed from power. A momentary
press of the "On/Off" keypad will reset this alarm condition.
(See Alarms section on page 12).
Turning your appliance ON and OFF:
If the appliance is "On", (and out of sleep mode) the
temperature will be shown in the display area of the control.
To turn the appliance "Off", press and hold the "On/Off"
keypad for 4-seconds. "OFF" will now be displayed on the
control.
To turn the appliance "On", press and hold the "On/Off"
keypad for 4-seconds.
Sleep mode:
If no keypads are pressed for 60 seconds, the display will
enter sleep mode to conserve power. The control panel
will go dark with the exception of the system status "OK"
indicator which will remain enabled. Alarm conditions will
wake the display, (see alarms on page 12).
To make the following changes to the control
settings (turning the appliance ON/OFF, adjusting the
temperature, and activating vacation mode), the control
must be awake.
The sleep mode can be disabled if you prefer to have the
display on continuously. Press and hold the "Lock" keypad
until the display goes past "Loc" and reads "nSL". To
enable the sleep mode, repeat the instruction, again going
past "Loc" until the display reads "SLP".
To wake the display press any keypad. A confi rm tone will
sound, and the current storage compartment temperature
will be displayed.
USING YOUR ELECTRONIC CONTROL
Loading ...
Loading ...
Loading ...