Loading ...
Loading ...
Loading ...
18
CONTROL WITHOUT THE REMOTE
• The appliance can be controlled through your Dyson Link app.
DYSON LINK APP CONNECTIVITY
• You must have a live Internet connection in order for the Dyson Link app to work.
• The appliance can connect to either 2.4GHz or 5GHz networks which includes most
modern routers. Check your router documentation for compatibility.
• The Dyson Link app requires an iOS device with at least iOS version 10* or an Android
device with at least Android version 5.
• Your mobile device must have Bluetooth
®
wireless technology 4.0 support (Bluetooth
®
wireless technology Low Energy) in order to set up a connection with the appliance.
Check your device specification for compatibility.
Supported Wi-Fi protocols:
– IEEE802.11a
– IEEE802.11b (Not recommended)
– IEEE802.11g
– IEEE802.11n
REPLACEABLE PARTS
BATTERY REPLACEMENT
CAUTION
• Unscrew the battery compartment on the remote control. Loosen the base
and pull to remove the battery.
• Do not install backwards or short circuit the batteries.
• Do not attempt to dismantle or charge the batteries. Keep away from fire.
• Follow battery manufacturers' instructions when installing new batteries
(battery type CR 2032).
• Always replace the screw in the remote control and refer to the battery hazard
in the warning section.
NON-WASHABLE FILTER UNITS
• Your filter units are non-washable and non-recyclable.
• To replace your filter units follow the steps as shown.
• Failure to replace the filter units when prompted may result in changes to product
performance and appearance.
• New filter units can be purchased at www.dyson.com.au/support (AU)
or www.dyson.co.nz/support (NZ).
AUTO MODE
• A period of 6 days is required after the appliance is first used for the sensor to
calibrate. During this period the appliance may be more sensitive to VOCs (such as
odours) than normal.
• During first use, whilst the sensors calibrate, the appliance can take up to 60 minutes
to show VOC and NO2 data.
AUTOMATIC CUT-OUT
• For your safety this appliance is fitted with automatic cut-out switches that operate if
the appliance tips over or overheats. If the switches operate, unplug the appliance and
allow it to cool. Before restarting the appliance check and clear any blockages and
ensure that the appliance is on a solid level surface.
• In heating mode the appliance will automatically switch ‘OFF’ after 9 hours of
continuous use. To restart the machine, press the Standby ON/OFF button on either
the remote control or the base, or restart via the Dyson Link app.
DISPOSAL INFORMATION
Dyson products are made from high grade recyclable materials. Please dispose of this
product responsibly and recycle where possible.
When your Dyson appliance reaches the end of its life, we are responsible for its safe
disposal. You can send your old Dyson appliance back to us (at our cost) and we will
organise for it to be recycled.*
*Please note that not all parts are recyclable. Recycling of parts is subject to the
capabilities of 3rd party suppliers. Available in Australia only.
Simply:
1. Box up your old Dyson appliance.
2. Take the package to your local post office and send to the address below:
Dyson We Recycle
Reply Paid 83215
Dyson Service Centre
8–10 Mangrove Lane
Taren Point, NSW 2229
• Keep the used batteries away from children as these can still harm children
if swallowed.
• Your filter units are non-washable and non-recyclable.
Additional information
04.10.2018 15:07 - C97193-DYS_OPMAN_ANZ_X527-PURE-HOT+COOL-OPMAN_15_4c0s
Loading ...
Loading ...
Loading ...