Loading ...
Loading ...
Loading ...
uuOperating the Switches Around the Steering WheeluAuto High-Beam
180
Controls
To activate the system, turn the headlight
switch to AUTO and then set the headlights
to low beam. The auto high-beam indicator
will come on.
2 Light Switches P. 175
The high beams remain on unless:
• The speed of the vehicle drops below 30 mph (48 km/h).
• The windshield wipers have been running at a high speed for more than a few
seconds.
• You enter a well lit location.
■
Operating the System
1Operating the System
For the auto high-beam system to work properly:
• Do not place an object that reflects light on the
dashboard.
• Keep the windshield around the camera clean.
• Do not attach an object, sticker or film to the area
around the camera.
If the camera receives a strong impact, or repairing of
the area near the camera is required, consult a dealer.
If the Some Driver Assist Systems Cannot
Operate: Camera Temperature Too High message
appears:
• Use the climate control system to cool down the
interior and, if necessary, also use defroster mode
with the air flow directed towards the camera.
• Start driving the vehicle to lower the windshield
temperature, which cools down the area around
the camera.
If the Auto high-Beam Cannot Operate: Clean
Windshield message appears:
• Park your vehicle in a safe place, and clean the
windshield. If the message does not disappear after
you have cleaned the windshield and driven for a
while, have your vehicle checked by a dealer.
Headlight
Switch
19 PILOT HMA ELP-31TG76300.book 180 ページ ２０１８年６月６日 水曜日 午後６時５分
Loading ...
Loading ...
Loading ...