Loading ...
Loading ...
Loading ...
20INSTALLATION
Connecting the Water Line
Before You Begin
This water line installation is not covered by the
refrigerator warranty. Follow these instructions
carefully to minimize the risk of expensive water
damage.
Water hammer (water banging in the pipes)
in house plumbing can cause damage to
refrigerator parts and can lead to water leakage
water hammer before installing the water supply
line to the refrigerator.
If you use your refrigerator before connecting
the water line, make sure the icemaker power
switch is in the OFF (O) position.
Water Pressure
You will need a cold water supply. The water
pressure must be between 20 and 120 psi
(0.14 y 0.82 MPa) on models without a water
connected to your cold water supply, this water
line installation is not covered by the refrigerator
warranty. Follow the following instructions
carefully to minimize the risk of expensive water
damage.
connected to your cold water supply, the water
pressure to the reverse osmosis system needs
to be a minimum of
40 to 60 psi (0,28 y 0,41 MPa)
capacity
If the water pressure from the reverse osmosis
system is less than 21 psi or 0,14 MPa takes more
the reverse osmosis system is blocked.
Allow the storage tank on the reverse
usage.
If the issue concerning water pressure
from reverse osmosis remains, call a
All installations must be in accordance
with local plumbing code requirements.
CAUTION
To prevent burns and product damage, only
connect the refrigerator water line to a cold
water supply.
CAUTION
Do not install the icemaker tubing in areas
where temperatures fall below freezing.
CAUTION
Wear eye protection during installation to
prevent injury.
ENGLISH
What You Will Need
Copper Tubing,
.
¼ in. (6.35 mm) outer
diameter, to connect the refrigerator to
the water supply. Be sure both ends of
.erauqs tuc era gnibut eht
To determine how
much tubing you need:
measure the distance
from the water valve on the back of the
refrigerator to the water supply pipe.
Then, add 8 feet (2.4 m).
(about 8 feet [2.4 m] coiled into three
turns of about 10 in. [25 cm] diameter)
to allow the refrigerator to move out
from the wall after installation.
Power drill.
.
½ in. (13 mm) or
.
adjustable wrench.
Flat blade and Phillips
.
head screwdrivers.
Two ¼ in. (6.35 mm)
.
outer diameter compression
nuts and 2 ferrules (sleeves)
to connect the
the refrigerator water valve.
Loading ...
Loading ...
Loading ...