Loading ...
Loading ...
Loading ...
INSTALLATION
I. GAS CONNECTION (Gas dryers only)
a. Remove the shipping cap from gas pipe at the rear of
the dryer.
NOTE: DO NOTconnect the dryer to L.Rgas service without
converting the gas valve. An L.R conversion kit must
be installed by a qualified gas technician.
Connect a 1/2 inch (1.27 cm) I.D. semi-rigid or approved
pipe from gas supply line to the 3/8 inch (0.96 cm) pipe
located on the back of the dryer. Use a I/2 inch to 3/8
inch (1.27 cm to 0.96 cm) reducer for a connection.
Apply an approved thread sealer that is resistant to the
corrosive action of liquefied gaseson all pipe connections.
c. Open the shutoff valve in the gas supply line.
d. Testallconnections bybrushing on asoapy water solution.
NEVER TESTFOR GAS LEAKS WITH AN OPENFLAME.
2. Connect the exhaust duct to outside exhaust system. Use
duct tape to seal all joints.
3. With the dryer in its final position, adjust one or more of the
legs until the dryer is resting solid on all four legs. Placea
level on top of the dryer. THE DRYER MUST BE LEVEL
AND RESTING SOLID ON ALL FOUR LEGS.
4. Plug the power cord into a grounded outlet.
NOTE: Check to ensure the power isoff at circuit breaker/
fuse boxbefore plugging the power cord into the outlet.
5. Turn on the power atthe circuit breaker/fuse box.
Before operating the dryer, make sure the
dryer area is clear and free from combustible materials,
gasoline, and other flammable vapors. Also see that
nothing (such as boxes, clothing, etc.) obstructs the flow
of combustion and ventilation air
6. Run the dryer through a cycle check for proper
operation.
NOTE: On gas dryers, before the burner will light, it is
necessary for the gas line to be bled of air. If the burner
does not light within 45 seconds the first time the dryer is
turned on, the safety switch will shut the burner off. If this
happens, turn the timer to "OFF" and wait 5 minutes before
making another attempt to light.
If your dryer does not operate, please review the "Avoid
Service Checklist" located in your Owner's Guide before
calling for service.
Placethese instructions in a location near the dryer for futu re
reference.
NOTE:
A wiring diagram islocated inside the dryer console or
behind the right side panel.
REPLA CEMENT PARTS
If replacement parts are needed for your dryer, call Sears
Parts and Service Toll Free Number 1-800-366-PART (1-
800-366-7278).
Label all wires prior to disconnection when
servicing controls. Wiring errors can cause improper and
dangerous operation. Verify proper operation after servicing.
Destroy the carton and plastic bags after the
dryer is unpacked. Children might use them for play. Cartons
covered with rugs, bedspreads, or plastic sheets can become
airtight chambers causing suffocation. Place all materials in a
garbage container or make materials inaccessible to children.
The instructions in this manual and all other
literature included with this dryer are not meant to cover every
possible condition and situation that may occur. Good safe
practice and caution MUSTbe applied when installing, operating
and maintaining any appliance.
10
Loading ...
Loading ...
Loading ...